Controller Features
2.Press SELECT again to display one of the “Clean” screens shown below.
4.Press SELECT again to display the “97%” screen.
Figure 27
CLEAN: This feature is beneficial on water supplies containing iron and/or high amounts of sediments (sand, silt, dirt, etc.). When set to ON, a backwash and fast rinse cycle will occur first, preceding the normal regeneration sequence. This provides extra cleaning of the resin bed before it is regenerated with the salt brine. To conserve water, if your water supply does not contain iron or sediments, be sure this feature is set to OFF. The default is OFF. Use the r UP or s DOWN buttons to change between OFF and ON.
3.Press SELECT again to display the “Clean Time” screen shown below.
Figure 28
CLEAN FEATURE MINUTES: If you have set the Clean Feature ON, the length of the extra backwash cycle automatically is set to 2 minutes. However, you can adjust this time from 1 to 15 minutes in length. To change this cycle time, use the r UP button to increase the time, or the s DOWN button to short- en the time. If no change is desired, continue to next step.
Figure 29
97% FEATURE: The 97% Feature can save salt and water by regenerating when 97% of the softener’s capacity has been used up. With this feature ON, the regeneration can occur at any time (whenever the system has reached 97% of its capacity). The default is OFF. If this feature is desired, turn it on by pressing the r UP button.
5.Press SELECT again to display the “12 or 24 hr” screen.
Figure 30
12 OR 24 HOUR CLOCK: All time displays are shown in standard clock time (1 to 12 AM; and 1 to 12 PM) at the 12 hr default setting. If 24 hour time format is desired, set to 24 hr by pressing the r UP button.
Questions? Call the Kenmore Water Line
18