Kenmore 625.385200 What Your Hybrid Water Softener Will Do, Controller Features, Extra Recharge

Page 16

What Your Hybrid Water Softener Will Do

The Kenmore Elite® Hybrid Water Softener has been designed to include two different types of media, a high quality media that reduces tastes and odors and a high efficiency media to remove hardness minerals. This Hybrid Water Softener will provide you and your home all the benefits of soft water, while providing whole home chlorine taste and odor reduction and bar- ium and radium 226/228 reduction. You can have fil-

tered water from your kitchen faucet for food prepara- tion and drink, in the bath and shower which will reduce chlorine’s aesthetic effect on your skin and hair, and at every bathroom sink for brushing your teeth. There are no filters to change.

Based on NSF-tested rated capacity under NSF/ANSI Standard 42*, the Kenmore Elite® Hybrid Water Softener has an estimated useful life for chlorine taste and odor reduction of over 10 years.

*NSF rated capacity is 570,000 gallons.

Controller Features

EXTRA RECHARGE

Sometimes, a manually initiated recharge (regeneration) may be desired, or needed. Two examples are:

= You have used more water than usual (guests visiting) and you may run out of soft water before the next automatic regeneration.

= You did not add salt to the softener before it ran out. Add salt to the softener before regenerating.

You can start a regeneration immediately, or you can set the controller to regenerate at the next preset recharge time (2:00 AM, or as set).

RECHARGE NOW

Press the REGENERATION button and hold for 3 sec- onds, until the words “RECHARGE”, “Serv” and “Fill” begin to flash in the display. The softener enters the fill cycle of regeneration immediately. This regeneration will take about 2 hours to complete. Then, you will have soft water again.

NOTE: If the “Clean Feature” is set ON, the normal regeneration cycle is preceded by a cleaning backwash and rinse. The words “CLEAN” and “Bkwsh” or “Rinse” flash in the display, along with the minutes of the clean cycle remaining.

Figure 22

RECHARGE TONIGHT

Press and release (do not hold) the REGENERATION button. “RECHARGE TONIGHT” will begin flashing in the display, and the softener will begin regeneration at the next preset recharge time (2:00 AM, or as set). If you decide to cancel the regeneration before it starts, press and release the REGENERATION button once more. “RECHARGE TONIGHT” will stop flashing in the display.

Figure 23

Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Hybrid Water Softener Warranty Warranty on Kenmore Elite Hybrid Water SoftenerTable of Contents Safety GuidesSpecifications & Performance Claims SpecificationsDimensions Performance ClaimsBarium 10 ±10% mg/L Mg/L Radium 226/228 25 pCi/L PCi/L Chlorine ±10% mg/L 50%Plan Your Installation Packing ListLine Outside Faucet Hard waterInstallation Check Your Water Pressure Before InstallingBypass Valve or Plastic Clip Alternate Bypass Valve InstallationBypass valve with a wet rag Ring Incoming Hard Water Connect the Valve Drain Hose Install Covers Connect to Electrical PowerMetal Pipe Grounding Rinse OUT Carbon FinesLeak Test Restart the Water HeaterSingle Bypass Valve Valve BypassProgramming the Softener Blue LightProgram the Softener SET Present Time of DAYSET Water Hardness Number SET Salt TypeFlushing the System Adding Salt to the Storage TankAdding Salt to the Storage Tank Water Softening Salt with Iron Removing AdditivesController Features What Your Hybrid Water Softener Will DoExtra Recharge Recharge NOWOptional Settings = Salt Efficiency = Clean Feature Salt Monitor SystemPress Select again to display the 12 or 24 hr screen Tank Light Press Select again to display the Recharge Days screenPress Select to return to the normal run time of day screen Tank Light IconWater Flow Through the Softener Recharge Time Remaining & Valve Position IndicatorsProgram Memory Service Information Care of Your Water SoftenerSalt Bridge TenerTroubleshooting Problem Cause CorrectionManually Initiated Electronic Diagnostics Resetting to Factory DefaultsPosition Markers valve in service Wiring Schematic Water Softener Exploded View Softener Parts List Valve Assembly Exploded View Valve Parts List Page For Iowa USE only ModelGet it fixed, at your home or ours
Top Page Image Contents