E. FILL THE STORAGE TANK WITH SALT
Brine (salt dissolved in water) is needed for each and
every regeneration. The water for makingbrine is me- tered into the salt storage tankby the softener. Howev- er, you must keep salt in the tank but it is not necessary to keep it full. In humid areas, it is best to fill the stor- age tank one quarter to one half full, and to refill it more often. Salt bridging (see page
often when conditions are humid.
Fill the tankwith NUGGET or PELLET water softener salt. DO NOT use rock salts, as they have dirt and sedi- ments that will stop the softener from working.
Before filling, be sure the brinewell cover is in place on the top of the brinewell. Salt storage capacity is shown
on page
(see page 2-1).
Note: The salt monitor system, page
The monitor will not work as accurately with other
types of salt including rock and solar.
If you choose Potassium Chloride (KC1) as a regener-
ant, following these suggestions will help give you
years of maintenance free service.
1)Place only one bag of KC1 in your softener at a time (the salt storage tank should contain no more than 60 pounds of KC1 at any one time).
2)A softener using KC1 should not be placed in areas
with temperature fluctuations and high humidity
(KC1 will harden in these environments and may make the softener inoperable).
3)Check the brine tank and brine well (black tube in
salt storage tank) monthly. If hardening is present,
pour small amounts of warm water on hardened areas until they loosen.
4)If your softener does not have a KC1 salt setting you must increase your hardness setting by 25% to ensure
continuous soft water as in example below.
Raw Water | Hardenss | Softener setting when | |
(grains per | gallon) | using KCI | |
5 gpg | 7 gpg | ||
10 gpg | 13 gpg | ||
15 gpg | 19gpg | ||
2O gpg | 25 gpg | ||
| + 25 | % - |
|
25 gpg | 32 | gpg | |
30 gpg | 38 | gpg | |
35 gpg | 44 | gpg | |
40 gpg | 50 | gpg |
WATER SOFTENING SALT WITH IRON REMOVING
ADDITIVES -- Some sahs have an additive to help the
softener handle iron in the water supply. These salts
may be used if your water supply has a high iron con-
tent. It is recommended to use Sears Resin Bed Clean-
er 42 - 34426, for periodic treatments to keep your resin bed clean. This is available at your local Sears store.
II I
li
brinewell
cover
bdnewell
salt
storage
tank
Sodium information: Water softeners using sodium
chloride for regeneration add sodium to the water.
Persons who are on sodium restricted diets should
consider the added sodium as part of their overall so-
dium intake. For example, if your water supply is 15 grains hard, you would have to drink 3 quarts of soft-
ened water to consume 335 milligrams of sodium.
That is equivalent to eating
Persons who are concerned about their drinkingwater
should consider a Kenmore Drinking Water System that will remove or reduce in excess of 90% of the so-
dium and other drinking water contaminants.
Problems, Questions? Call