Gemini CD-12 Programming Instructions, Trouble Shooting, Specifications, General, Audio Section

Page 4

To fine tune a cue point, pause play at the memorized cue point, then use the SCAN BUTTONS (13) to scan frame by frame (1/75th of a second) to where you want play to begin. Press the PLAY/PAUSE BUTTON (10) to save the new cue point.

Note: During fine tuning there will be a stutter effect (to help you find the beat). The stuttering effect will end when you press the PLAY/PAUSE BUTTON (10) to save the cue point. Also, during fine tuning if you hold down the SCAN BUTTONS (13), the unit will scan quickly after 10 frames.

PROGRAMMING INSTRUCTIONS

1.To program the unit to play songs in the order you select using the TRACK NUMBERS (15) on the remote control, follow these instruc- tions:

In stop mode, press the PROGRAM BUTTON (6) and then choose the tracks you wish to play by pressing the TRACK NUMBERS (15) on the remote control. Press the PLAY/PAUSE BUTTON (10) to play your programmed selections.

2.To program the unit to play songs in the order you select using the SCAN BUTTONS (13), follow these instructions:

In stop mode, press the PROGRAM BUTTON (6) and then choose the track you wish to play using the TRACK SKIP BUTTONS (12). Press the PROGRAM BUTTON (6) to save the track. Repeat the process until you are ready to start playing your selections. Press the PLAY/PAUSE BUTTON (10) to play your programmed selections.

3.To clear items from your program, press the STOP/CLEAR BUTTON (11).

TROUBLE SHOOTING

If the disk will not play, check to see if the disc was loaded correctly (label side up). Also check the disc for excessive dirt, scratches, etc.

If the disc turns but there is no sound, check the cable connections. If they are okay, check your amplifier or receiver.

If the CD skips, check the CD for dirt or scratches. Do not assume that the CD player is defective. Many CDs are recorded out of spec and will skip on most or all CD players. Before sending the unit in for repair, try playing a CD that you are sure plays properly.

SPECIFICATIONS

GENERAL:

 

 

 

 

 

Type

Compact Disc Player w/wireless

remote

Disc Type

Standard Compact discs (12 cm & 8 cm)

Time Display

Track Elapsed, Track Remain, or Total remain

Variable Pitch

+/- 8% Slider with Resume Switch

Start

Within

0.03

 

seconds

Track Selection

 

1 to 99 Tracks

Installation

19"

Rack

Mountable

AUDIO SECTION:

 

 

 

 

 

Quantization

1 Bit Linear/Channel, 3 Beam Laser

Oversampling Rate

 

 

8 Times

Sampling Frequency

 

44.1 kHz

Frequency Response

20 Hz

to

20 kHz

Total Harmonic Distortion

Less Than 0.05%

Signal to Noise

Ratio

 

 

>96 dB

Dynamic Range

 

 

 

>94 dB

Output Level (nominal)

1.9 Volts R.M.S.

Power Supply

AC 120/230V, 60/50 Hz

Dimensions

16.5” x 10.6” x 3.5” (420 x 270 x 90 mm)

Weight

 

7.75 lbs. (3.5 kg)

*Specifications and design are subject to change without notice for purpose of improvement.

Page 4

Image 4
Contents CD-12 Line OUT Safety Certifications IntroductionLine Voltage Selection Operating InstructionsTrouble Shooting SpecificationsProgramming Instructions GeneralEinleitung VorsichtsmassnahmenSicherheitsbescheinigung Wahl DER NetzspannungMerkanleitung ProgrammieranleitungFehlersuche Technische DatenIntroducción PrecaucionesCertificaciones DE Seguridad Selección DEL Voltaje DE LíneaResolución DE Problemas Instrucciones DE Punto DE ReferenciaInstrucciones DE Programación EspecificacionesPrécautions Certifications DE SécuritéChoix DE LA Tension DU Secteur ConnexionsConsignes D’INSERTION Instructions DE ProgrammationDépannage Spécifications TechniquesIntroduzione PrecauzioniCertificazioni DI Sicurezza Selezione DEL VoltaggioIstruzioni PER LA Programmazione Localizzazione ED Eliminazione DI UN GuastoCaratteristiche Caratteristiche GeneraliDo not attempt to return this equipment to your dealer