Do not overtighten | Bradley Smoker SS-2/AST/STD, SS-2/AST/JUV

Bradley Smoker SS-2/AST/STD, SS-2/AST/JUV installation instructions Do not overtighten

Page 8

Express® Lavatory System SS-Series
SS-2/AST/STD, SS-2/AST/JUV	Installation Instructions - For Service Only

Step 3: Installing bowl assembly

IMPORTANT: Moving and positioning the bowl will require more than one person.

Note: Refer to Figure 5 below when installing the bowl assembly.

1.With someone to assist you, place the bowl assembly squarely onto the frame.

2.Attach the front of the bowl assembly to the frame using the two 1/4"-20 x 3/8" pan-head screws and washers. Do not tighten screws at this time.

IMPORTANT: When bolting the bowl assembly to the frame and wall, do not overtight- en bolts. Overtightening bolts can damage the Terreon® material.

3.After the bowl assembly is attached to the frame, use two 3/8" bolts and washers (supplied by the installer) to bolt the bowl to the wall anchors.

4.Tighten the screws installed in procedure #2 above to secure the bowl assembly to the frame.

Do not overtighten.

BACK VIEW

BOWL ASSEMBLY

3/8" BOLT AND

WASHER

3/8" BOLT AND WASHER

5/11/04

Bradley Corporation • 215-1244 Rev. C; EN 03-813

Image 8

Contents

For Service Only Table of ContentsPre-Installation Information Supplies required for installationBarrier-free and ADA compliant standard height mounting Barrier-free and ADA compliant juvenile height mountingSS-2/AST/STD Express Lavatory System Dimensions Standard Height MountingStandard Height Juvenile Height SS-2/AST/JUVRough Installation InstructionsInstallation Instructions continue SS-2/AST/JUV Express Lavatory System Dimensions Juvenile Height MountingMounting frame to wall Do not overtighten Connecting supply and drain Connecting plastic tubing Completing installation Cleaning and Maintenance Instructions Terreon and panel maintenanceCleaning Panel cleaningSoap Dispenser Maintenance Fill soap dispensersCheck Valve Troubleshooting Cleaning InstructionsIf water just dribbles or does not flow from sprayhead If water sprayhead delivers all hot or cold waterOptional Stop/Strainer/Check Valve Assembly of ComponentsPaneling Other Replacement Parts Pushbutton assemblyMetering Air Valve Maintenance Metering Air Valve TroubleshootingMetering Air Valve Repair Kits and Parts List Problem Water is dripping from the streamformersProblem Valve will not shut off Problem Valve will not turn onProblem Timing can not be adjusted for more than 5 seconds Problem Pushbutton does not work properlyService Suggestions Vernatherm Mixing Valve Maintenance and ServiceMaintenance Instructions