7 CONNECT FRONT PANEL TO |
ELECTRICAL BOX (AC POWER); |
Fig. 10 |
1. Remove the four COVER SCREWS (1) and COVER |
from (2) ELECTRICAL BOX (4). Fig. 10. |
2. Pull the CIRCUIT BOARD (3) out from ELECTRICAL |
BOX (4). Fig. 10. |
3. Knock out lower blank in ELECTRICAL BOX (4) with |
flat blade screwdriver. Install from the back of |
ELECTRICAL BOX (4) the POWER SUPPLY GROMMET |
(8). Fig. 10a. |
Fig. 10
1
4
2
3
4. Attach the SAFETY CHAIN (5) from the FRONT |
PANEL (6) to the MOUNTING POST (7) as shown. |
Feed the Red and Black wires through the back opening |
in the ELECTRICAL BOX (4). Fig. 10a. |
5. From back of ELECTRICAL BOX (4) remove SPLIT |
PLUG (8a) from POWER SUPPLY GROMMET (8). Insert |
POWER CORD CONNECTOR (9) through POWER |
SUPPLY GROMMET (8). Insert POWER CORD (10) into |
SPLIT PLUG (8a). Push SPLIT PLUG (8a) into POWER |
SUPPLY GROMMET (8) to seal. Fig. 10b. |
6. Insert POWER SUPPLY CONNECTOR (9) into |
RECEPTOR (11) on CIRCUIT BOARD (3). Install |
CIRCUIT BOARD (3) into ELECTRICAL BOX (4). |
Fig. 10b. |
Fig. 10a
4
8 
KNOCK OUT
BLANK
6
T O P
7
5
BLACK &
RED WIRES
7. Install the SENSOR WIRE GROMMET (15) into the |
Fig. 10b
COVER (2) as shown. Remove the SPLIT PLUG (15a) |
from SENSOR WIRE GROMMET (15). Insert SENSOR |
WIRE CONNECTOR (12) through SENSOR WIRE |
GROMMET (15). Insert SENSOR WIRE (13) into SPLIT |
PLUG (15a). Push SPLIT PLUG (15a) into SENSOR |
WIRE GROMMET (15) to seal. Fig. 10c. |
8. Insert SENSOR WIRE CONNECTOR (12) into |
CIRCUIT BOARD RECEPTOR (14) slot. Fig. 10c. |
9. Replace COVER (2). Tighten COVER SCREWS (1) |
firmly. |
9 | 3 | 4 |
|
|
8 11
8a 9
10
T O P
7
8
Fig. 10c
12
13
15 15a
2
1
T O P
14 |
6 | M968550 REV. 1.5 |
|