American Standard 6059.193 Electrical Installation, Electrical Connections Fig

ELECTRICAL INSTALLATION

1ELECTRICAL CONNECTIONS; Fig. 1

	Before opening ENCLOSURE
CAUTION
	disconnect AC power supply.

1.Remove ENCLOSURE COVER (1). Fig. 1.

2.Feed the WIRE CONNECTORS (2) through the top of ENCLOSURE (5). Fig. 1a.

3.Remove GROMMET (4) from ENCLOSURE (5). Fig. 1.

4.Feed the gray SENSOR WIRE (7) through GROMMET (4), 4" from CONNECTOR. Fig. 1b. Insert gray SENSOR WIRE (7) into SPLIT PLUG (9). Push SPLIT PLUG (9) into GROMMET (4) to seal. Fig. 1d.

5.Insert GROMMET (4) back into ENCLOSURE (5).

Fig. 1c.

6.Install CIRCUIT BOARD (3) into ENCLOSURE (5) with SENSOR WIRE (7) under BOARD. Fig. 1c.

7.Insert SENSOR WIRE CONNECTOR (8) and EXTENSION WIRE CONNECTOR (11) into available CIRCUIT BOARD RECEPTORS (10) slots. Fig. 1e.

8.Connect wires from SENSOR to SOLENOID VALVE

(6) (Red to +, Black to -). Fig. 1d.

9.Replace ENCLOSURE COVER (1). Tighten cover screws firmly.

10.Contractor to supply ELECTRICAL BOX (12)

and connection to ENCLOSURE (5). Mount POWER SUPPLY (13) into ELECTRICAL BOX (12). Connect White and Black power connections to POWER SUPPLY CABLE (14). Fig. 1f.

11.Connect the EXTENSION WIRE (16) to the POWER SUPPLY CABLE (15). FIG. 1f.

Fig. 1f

	4" ELECTRICAL BOX
12	OR EQUIVALENT BY
	OTHERS
				16
14			15
BLACK & WHITE
POWER		CONNECTOR NOT
CONNECTIONS 13
		USED IN THIS
		INSTALLATION

Fig. 1	4	1
5

Fig. 1a Fig. 1b

4"

5

4

7

Fig. 1c 5 7

26

BLACK

Fig. 1d

94

7

Fig. 1e

8

10

11

10

4

RED

8

3

4

M 9 6 5 2 7 1