American Standard 6059.193 General Cleaning Fig, HOW to Clean and Remove the Flow Restrictor Fig

4HOW TO CLEAN AND REMOVE THE FLOW RESTRICTOR; Fig. 4

1.Remove SET SCREW (1) with FLAT BLADE SCREWDRIVER (2). Pull off SPOUT (3) from faucet base. Fig. 4 & 4a.

2.Remove HOUSING (4) and remove FLOW RESTRICTOR (5). Fig. 4b.

3.Rinse clean FLOW RESTRICTOR (5). Reassemble and install into SPOUT BASE (6). Reassemble SPOUT

(3) onto SPOUT BASE (6) and tighten SET SCREW (1).

Fig. 4.

5GENERAL CLEANING; Fig. 5

1.For general cleaning use a damp, soft cloth to clean the spout and the sensor.

2.For cleaning dirt use a soft cloth with diluted dish washing detergent. Wipe the area using a wet cloth and dry using a soft cloth.

CAUTION

Do not scratch the sensor when cleaning.

Avoid using anything that may scratch the spout surface. Never use polishing power, detergent or a nylon scrub brush. They will damage the surface of the spout or Sensor.

Fig.4		1		3
	2		REMOVE SET SCREW (1)

Fig.4a	Fig.4b
	4
3	5
	PULL UP TO
	REMOVE SPOUT

4

6

Fig.5

7 M 9 6 5 2 7 1