SELECTING OPERATION MODES
1 | Press | to start the operation. |
2 | Press | to select operation mode. Each press |
| changes mode in the following order: | |
|
| (I FEEL) |
|
| (COOL) |
|
| (DRY) |
|
| (FAN) |
3 | Press | or to set the temperature. |
| Each press raises or lowers the temperature by 1°C. | |
| Press | to stop the operation. |
| • The same setting is selected the next time by simply pressing . | |
Operation indicator lamp
The operation indicator lamp shows the operation state of the unit.
Indication | Operation state | Room temperature |
The unit is operating to reach the set | About 2°C or more away | |
temperature | from set temperature | |
The room temperature is approaching | About 1 to 2°C from set | |
the set temperature | temperature | |
Lighted | Not lighted |
|
I FEEL mode
The unit selects the operation mode according to the room temperature when I FEEL is selected. When the room temperature is higher than 25°C, COOL is selected (set temperature: 24°C). When the room temperature is lower than 25°C, DRY is selected. However, when operation is stopped and then started within 2 hours, the mode which has been selected previously is operated.
Note:
During COOL operation, the set temperature may not be changed when the room temperature is more than 2°C higher than the set temperature. In this case, please wait until the room temperature drops to within 2°C of the set temperature.
COOL mode
Enjoy cool air at your desired temperature.
DRY mode
Dehumidify your room. The room may be cooled slightly.
Temperature cannot be set during DRY mode.
FAN mode
Circulate the air in your room.
Emergency operation
When the remote controller cannot be used...
Emergency operation can be activated by pressing the emergency operation switch (E.O.SW) on the indoor unit.
Each time the E.O.SW is pressed, the operation changes in the following order:
Operation indicator lamp
Emergency COOL | Set temperature : 24°C |
| |
| Fan speed : Medium |
Stop | Horizontal vane : Auto |
|
Note:
The first 30 minutes of operation is test run. Temperature control does not work, and fan speed is set to High.
Auto restart function
If a power failure occurs or the main power is turned off during operation, “Auto restart function” automatically starts operation in the same mode as the one set with the remote controller just before the shutoff of the main power. When timer is set, timer setting is cancelled and the unit starts operation when power is resumed.
If you do not want to use this function, please consult the service representative because the setting of the unit needs to be changed.