Electrolux FMV156DBE Component Replacement and Adjustment Procedure, Hood Exhaust Louver Removal

Page 29

FMV156DBE

FMV156DSE

FMV156DQE

FMV156DCF

COMPONENT REPLACEMENT AND ADJUSTMENT PROCEDURE

WARNING AGAINST HIGH VOLTAGE:

Microwave ovens contain circuitry capable of producing very high voltage and current, contact with following parts may result in severe, possibly fatal, electric shock.

(Example)

High Voltage Capacitor, Power Transformer, Magnetron, High Voltage Rectifier Assembly, High Voltage Harness etc..

WARNING: Avoid possible exposure to microwave energy. Please follow the instructions below before operat- ing the oven.

1.Disconnect the power supply cord.

2.Make sure that a definite” click” can be heard when the microwave oven door is unlatched. (Hold the door in a closed position with one hand, then push the door open button with the other, this causes the latch leads to rise, it is then possible to hear a “click’ as the door switches operate.)

3.Visually check the door and cavity face plate for damage (dents, cracks, signs of arcing etc.).

Carry out any remedial work that is necessary before operating the oven.

Do not operate the oven if any of the following conditions exist;

1.Door does not close firmly.

2.Door hinge, support or latch hook is damaged.

3.The door gasket or seal is damaged.

4.The door is bent or warped.

5.There are defective parts in the door interlock system.

6.There are defective parts in the microwave generating and transmission assembly.

7.There is visible damage to the oven.

Do not operate the oven:

1.Without the RF gasket (Magnetron).

2.If the wave guide or oven cavity are not intact.

3.If the door is not closed.

4.If the outer case (cabinet) is not fitted.

WARNING FOR WIRING

To prevent an electric shock, take the following pre- cautions.

1.Before wiring,

1)Disconnect the power supply cord.

2)Open the door block it open.

3)Discharge the high voltage capacitor and wait for 60 seconds.

2.Don’t let the wire leads touch to the followiong parts;

1)High voltage parts:

Magnetron, High voltage transformer, High voltage capacitor and High voltage rectifier assembly.

2)Hot parts:

Oven lamp, Magnetron, High voltage transformer and Oven cavity.

3)Sharp edge:

Bottom plate, Oven cavity, Waveguide flange, Chassis support and other metallic plate.

4)Movable parts (to prevent a fault)

Fan blade, Fan motor, Switch, Open lever, Open button.

3.Do not catch the wire leads in the outer case cabinet.

4.Insert the positive lock connector until its pin is locked and make sure that the wire leads do not come off even if the wire leads are pulled.

5.To prevent an error function, connect the wire leads correctly, referring to the Pictorial Diagram.

Please refer to ‘OVEN PARTS, CABINET PARTS, CONTROL PANAL PARTS, DOOR PARTS’, when carrying out any of the following removal procedures:

THE FOLLOWING ADJUSTMENTS OR COMPONENT REPLACEMENT CAN BE PERFORMED

WITHOUT REMOVING THE OVEN FROM THE WALL

1.

Hood lamps, sockets, grease filter and charcoal filter.

4.

Hood exhaust louver.

2.

Base cover and hood lamp glass assembly.

5.

Control panel assembly or components.

3.

Turntable motor.

 

 

HOOD EXHAUST LOUVER REMOVAL

1.Disconnect the power supply cord.

2.Open the door and block it open.

3.To discharge the high voltage capacitor, wait for 60

seconds.

4.Remove the three (3) screws holding the hood exhaust louver to the oven cavity front face plate.

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Over the Range Microwave Oven Models Table of ContentsBefore Servicing Dont Touch Before Servicing When the testing is completedLeakage test Microwave Measurement ProcedureRequirements Electrolux General Information Product SpecificationOven Diagram Control Panel Description of Operating Sequence OperationRE-CIRCULATION Inside Venting Vertical VentingHorizontal Venting Figure O-1. Oven Schematic-Off Condition Functions Description and Function of ComponentsTroubleshooting Guide CK = Check / RE = Replace Power Transformer Test Procedure Component Test Letter Magnetron Assembly TestMicrowave Output Power Cavity Thermal CUT-OUT Test Magnetron Temperature Fuse TestHigh Voltage Capacitor Test TEMPERATURE, Replace Temperature Fuse Procedure Component Test LetterPrimary Interlock Switch Test Door Sensing SwitchSecondary Interlock Relay RY2 Monitor Switch TestHood FAN Motor Test ProcedureHood Thermal CUT-OUT Test Before testing Relay Test KEY Unit TestDefrost Center Test Foil Pattern on the Printed Wiring Board Test1ST Stage 2ND Stage Level TimeSteps Occurrence Cause or Correction Occurrence Cause or CorrectionRemoval Measuring Point Indication of OHM-METER Procedure Component Test Letter Noise Filter TestLSI Touch Control Panel AssemblyDescription of LSI OUT Oven lamp, fan motor and turntable motor driving signal Signal to sound buzzer 2.0 kHzSignal coming from touch key Signal similar to P46Hood lamp driving signal Key strobe signalHood motor driving signal Segment data signalServicing Other PrecautionsShapes of Electronic Components Servicing of Touch Control PanelHood Exhaust Louver Removal Component Replacement and Adjustment ProcedureRe-install Power Transformer RemovalPictorial Diagram Hood FAN Motor RemovalHigh Voltage Rectifier and High Voltage Capacitor Removal Magnetron RemovalHood FAN Thermal CUT-OUT Removal Thermal CUT-OUT Cavity RemovalSide View InstallationCooling FAN Motor Removal Control Panel ASSEMBLY, Control Unit and KEY Unit Removal Positive Lock Connector NO-CASE Type RemovalPositive lock connector Turntable MotorControl Unit and KEY Unit Removal Key unit locationDoor Assembly RE-INSTALL Door Replacementdoor Assembly RemovalDoor Frame Assembly Door DisassemblyChoke Cover Latch SPRING, Latch Head and Door PanelPictorial DiagramFigure S-2. Power Unit Circuit LSI Unit Circuit Figure S-4. Printed Wiring Board Electric Parts Parts ListCabinet Parts Control Panel PartsSCREWS,NUTS, Washers and Other Door PartsMiscellaneous Oven and Cabinet Parts Control Panel Parts Door Parts Miscellaneous Non-replaceable items Packing and AccessoriesFMV156DBE FMV156DSE FMV156DQE FMV156DCF FMV156DBE FMV156DSE FMV156DQE FMV156DCF FMV156DBE FMV156DSE FMV156DQE FMV156DCF

FMV156DBE specifications

The Electrolux FMV156DBE is a modern and versatile microwave oven that combines sleek aesthetics with cutting-edge technology, making it a popular choice for contemporary kitchens. This model offers a range of advanced features designed to streamline cooking and enhance convenience while ensuring users can prepare meals efficiently.

One of the standout features of the Electrolux FMV156DBE is its powerful 1.6 cubic feet capacity, which provides ample space for cooking various dishes, from reheating leftovers to defrosting frozen goods. Its 1,000-watt power output allows for fast and efficient cooking, ensuring that food is heated evenly and thoroughly. The microwave also features multiple power levels, enabling users to customize cooking intensity based on their specific needs.

This model is equipped with the Sensor Cooking technology, which automatically adjusts cooking time and power based on the moisture released from the food. This intelligent feature helps to prevent overcooking or undercooking, delivering perfectly prepared meals every time. Additionally, the FMV156DBE includes a range of pre-programmed cooking settings that cater to different food types, further enhancing usability and efficiency.

Another notable aspect of the Electrolux FMV156DBE is its intuitive touch control panel, allowing for easy navigation through cooking options and settings. The illuminated LED display enhances visibility, making it simple to monitor cooking progress at a glance. The microwave also features a convenient kitchen timer and a clock function, adding to its overall functionality.

The microwave not only excels in cooking performance but also in design. It features a contemporary stainless-steel finish that adds a touch of elegance to any kitchen decor. The streamlined design ensures it can fit seamlessly into various kitchen layouts, while the built-in design options provide flexibility for installation.

Safety is also a priority with the Electrolux FMV156DBE, which includes a child lock feature, preventing unintended use by little hands. This quality makes it an ideal appliance for families with children.

In summary, the Electrolux FMV156DBE is a highly functional microwave oven that features advanced cooking technologies, an ample cooking capacity, and a stylish design. With its combination of performance, convenience, and safety features, it serves as a valuable addition to any modern kitchen.
Top Page Image Contents