Electrolux FMV156DBE service manual Dont Touch Before Servicing, When the testing is completed

Page 3

FMV156DBE

FMV156DSE

FMV156DQE

FMV156DCF

WARNING TO SERVICE PERSONNEL

Microwave ovens contain circuitry capable of pro- ducing very high voltage and current, contact with following parts may result in a severe, possibly fatal, electrical shock.

(Example)

High Voltage Capacitor, High Voltage Power Transformer, Magnetron, High Voltage Rectifier Assembly, High Voltage Harness etc..

Read the Service Manual carefully and follow all instructions.

Don't Touch !

Danger High Voltage

Before Servicing

1.Disconnect the power supply cord , and then remove outer case.

2.Open the door and block it open.

3.Discharge high voltage capacitor.

WARNING: RISK OF ELECTRIC SHOCK. DISCHARGE THE HIGH-VOLTAGE CAPACITOR BEFORE SERVICING.

The high-voltage capacitor remains charged about 60 seconds after the oven has been switched off. Wait for 60 seconds and then short-circuit the connection of the high-voltage capacitor (that is the connecting lead of the high-voltage rectifier) against the chassis with the use of an insulated screwdriver.

Whenever troubleshooting is performed the power supply must be disconnected. It may, in some cases, be necessary to connect the power supply after the outer case has been removed, in this event,

1.Disconnect the power supply cord, and then remove outer case.

2.Open the door and block it open.

3.Discharge high voltage capacitor.

4.Disconnect the leads to the primary of the power transformer.

5.Ensure that these leads remain isolated from other components and oven chassis by using insulation tape.

6.After that procedure, reconnect the power supply cord.

When the testing is completed,

1.Disconnect the power supply cord, and then remove outer case.

2.Open the door and block it open.

3.Discharge high voltage capacitor.

4.Reconnect the leads to the primary of the power transformer.

5.Reinstall the outer case (cabinet).

6.Reconnect the power supply cord after the outer case is installed.

7.Run the oven and check all functions.

After repairing

1.Reconnect all leads removed from components during testing.

2.Reinstall the outer case (cabinet).

3.Reconnect the power supply cord after the outer case is installed.

4.Run the oven and check all functions.

Microwave ovens should not be run empty. To test for the presence of microwave energy within a cavity, place a cup of cold water on the oven turntable, close the door and set the power to HIGH and set the microwave timer for two (2) minutes. When the two minutes has elapsed (timer at zero) carefully check that the water is now hot.If the water remains cold carry out Before Servicing procedure and re-examine the connections to the component being tested.

When all service work is completed and the oven is fully assembled, the microwave power output should be checked and microwave leakage test should be carried out.

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Over the Range Microwave Oven Models Table of ContentsBefore Servicing Dont Touch Before Servicing When the testing is completedMicrowave Measurement Procedure RequirementsLeakage test Electrolux General Information Product SpecificationOven Diagram Control Panel Description of Operating Sequence OperationVertical Venting Horizontal VentingRE-CIRCULATION Inside Venting Figure O-1. Oven Schematic-Off Condition Functions Description and Function of ComponentsTroubleshooting Guide CK = Check / RE = Replace Procedure Component Test Letter Magnetron Assembly Test Microwave Output PowerPower Transformer Test Magnetron Temperature Fuse Test High Voltage Capacitor TestCavity Thermal CUT-OUT Test Door Sensing Switch Procedure Component Test LetterTEMPERATURE, Replace Temperature Fuse Primary Interlock Switch TestSecondary Interlock Relay RY2 Monitor Switch TestProcedure Hood Thermal CUT-OUT TestHood FAN Motor Test Before testing Relay Test KEY Unit TestLevel Time Foil Pattern on the Printed Wiring Board TestDefrost Center Test 1ST Stage 2ND StageOccurrence Cause or Correction RemovalSteps Occurrence Cause or Correction Measuring Point Indication of OHM-METER Procedure Component Test Letter Noise Filter TestTouch Control Panel Assembly Description of LSILSI Signal similar to P46 Signal to sound buzzer 2.0 kHzOUT Oven lamp, fan motor and turntable motor driving signal Signal coming from touch keySegment data signal Key strobe signalHood lamp driving signal Hood motor driving signalServicing of Touch Control Panel Other PrecautionsServicing Shapes of Electronic ComponentsHood Exhaust Louver Removal Component Replacement and Adjustment ProcedureHood FAN Motor Removal Power Transformer RemovalRe-install Pictorial DiagramThermal CUT-OUT Cavity Removal Magnetron RemovalHigh Voltage Rectifier and High Voltage Capacitor Removal Hood FAN Thermal CUT-OUT RemovalInstallation Cooling FAN Motor RemovalSide View Turntable Motor Positive Lock Connector NO-CASE Type RemovalControl Panel ASSEMBLY, Control Unit and KEY Unit Removal Positive lock connectorControl Unit and KEY Unit Removal Key unit locationDoor Assembly RE-INSTALL Door Replacementdoor Assembly RemovalLatch SPRING, Latch Head and Door Panel Door DisassemblyDoor Frame Assembly Choke CoverPictorial DiagramFigure S-2. Power Unit Circuit LSI Unit Circuit Figure S-4. Printed Wiring Board Control Panel Parts Parts ListElectric Parts Cabinet PartsDoor Parts MiscellaneousSCREWS,NUTS, Washers and Other Oven and Cabinet Parts Control Panel Parts Door Parts Miscellaneous Non-replaceable items Packing and AccessoriesFMV156DBE FMV156DSE FMV156DQE FMV156DCF FMV156DBE FMV156DSE FMV156DQE FMV156DCF FMV156DBE FMV156DSE FMV156DQE FMV156DCF

FMV156DBE specifications

The Electrolux FMV156DBE is a modern and versatile microwave oven that combines sleek aesthetics with cutting-edge technology, making it a popular choice for contemporary kitchens. This model offers a range of advanced features designed to streamline cooking and enhance convenience while ensuring users can prepare meals efficiently.

One of the standout features of the Electrolux FMV156DBE is its powerful 1.6 cubic feet capacity, which provides ample space for cooking various dishes, from reheating leftovers to defrosting frozen goods. Its 1,000-watt power output allows for fast and efficient cooking, ensuring that food is heated evenly and thoroughly. The microwave also features multiple power levels, enabling users to customize cooking intensity based on their specific needs.

This model is equipped with the Sensor Cooking technology, which automatically adjusts cooking time and power based on the moisture released from the food. This intelligent feature helps to prevent overcooking or undercooking, delivering perfectly prepared meals every time. Additionally, the FMV156DBE includes a range of pre-programmed cooking settings that cater to different food types, further enhancing usability and efficiency.

Another notable aspect of the Electrolux FMV156DBE is its intuitive touch control panel, allowing for easy navigation through cooking options and settings. The illuminated LED display enhances visibility, making it simple to monitor cooking progress at a glance. The microwave also features a convenient kitchen timer and a clock function, adding to its overall functionality.

The microwave not only excels in cooking performance but also in design. It features a contemporary stainless-steel finish that adds a touch of elegance to any kitchen decor. The streamlined design ensures it can fit seamlessly into various kitchen layouts, while the built-in design options provide flexibility for installation.

Safety is also a priority with the Electrolux FMV156DBE, which includes a child lock feature, preventing unintended use by little hands. This quality makes it an ideal appliance for families with children.

In summary, the Electrolux FMV156DBE is a highly functional microwave oven that features advanced cooking technologies, an ample cooking capacity, and a stylish design. With its combination of performance, convenience, and safety features, it serves as a valuable addition to any modern kitchen.
Top Page Image Contents