Electrolux RH36PC80GSB manual Control buttons

Page 15

Control buttons

15

 

 

 

 

 

Control buttons

This hood is equipped with an electronic motor and lamp control.

The control is able to set 4 different fan speeds, turn ON/OFF light and has a timer function.

In the following drawing are described the main key functions.

1.Light Button

Press lamp button to turn ON the light (Lamp state previously OFF).

Press lamp button to turn OFF the light (Lamp state previously ON).

2.Timer Button

The default timer setting is 10 minutes, and it can be adjusted between 20 minutes and 1minute.

After pressing the timer button, the control enters to a timer setup mode, and user can adjust the timer countdown time with the

“ ” and “ ” buttons within 5 seconds. The timer can be initiated immediately pressing the timer button, after setting the timer duration or pressing the timer button twice (default 10 minutes setting).

If no action occurs within 5 seconds, the countdown will start.

During the timer setup the “ ” and “ ” buttons are dedicated to the timer and no motor action will occur.

Once the timer is initiated, it can be cancelled by pressing the timer button again.

If the fan is at fourth speed and the “

 

button is pressed, the fan will be set to third

 

speed.

 

 

If the fan is OFF and the “

” button is

 

pressed, the control backlight will light up.

5.“ ” Button. Speed Increase / ON

This button is used to increase the fan speed, or turn ON the fan.

The fan will turn ON if the “ ” button is pressed and the hood was OFF.

If the fan is at first speed and the“ ” button is pressed, the fan will be set to second speed.

If the fan is at second speed and the “ ” button is pressed, the fan will be set to third speed.

If the fan is at third speed and the “ ” button is pressed, the fan will be set to fourth speed.

If the fan is at fourth speed and the “

 

button is pressed, a beep will sound.

 

3.Display

Shows the hood settings.

4.“ ” Button. Speed Decrease / OFF

This button is used to decrease the fan speed, or turn OFF the fan.

The fan will turn OFF if the “

” button is

 

pressed and the hood was in the first speed.

If the fan is at second speed and the “

 

buttom is pressed, the fan will be set to first

 

speed.

 

 

If the fan is at third speed and the “

 

key is pressed, the fan will be set to second

 

speed.

 

 

Image 15
Contents Installation, Use & Care Guide Questions? Table of contentsPlease read and save this guide Keep a record for quick referenceImportant Safety Instructions Read and Save These Instructions Before installing the hood Electrical requirementsDo not use flex ducting Tools/Materials required Optional accessoriesList of Materials Parts included in your hoodTypical installation Installing the hoodRemoving the packaging Installing preparationDuctwork and wiring locations Ductwork installation guidelinesFraming must be capable of supporting 150lbs Ceiling Support StructuresWith 8 assembly screws 2 per corner Installing the hood Ceiling ducting Failure to do so can result in death or electrical shockAC, 15 or 20 Amp circuit required Air deflect installation Recirculating accessories Connecting the ductworkFeatures Control buttons Special functions For Best results To Remove The Metal Grease Filters Care and cleaningTo Clean Filters FiltersHood Surface Charcoal filter placement Recirculating accessoriesCleaning Optional Charcoal FiltersWarranty Information LI288F