The water softener must be set in both ways: manually, using the water hardness dial and electronically, using the programme selection/cancel
button on the control panel
Setting manually
The dishwasher is factory set at position 2.
1.Open the dishwasher door.
2.Remove the lower basket from the dishwasher.
3.Turn the water hardness dial to position 1 or 2 (see table).
4.Replace the lower basket.
Setting electronically
The dishwasher is factory set at level 5.
1.Press the On/Off button. The dishwasher must be in setting mode.
2.Press and keep pressed the programme selection/cancel
button until programme light 1 flashes and programme light 2 illuminates with a fixed light.
first use electrolux 13
Wait until programme light 2 turns off, programme light 1 goes on flashing and simultaneously the
end of programmeindicator light starts flashing.
This indicates that you have activated the electronic setting function of the water softener.
The current level is indicated by the number of flashes of the end
of programme indicator light and a pause of a few seconds.
Examples:
5 flashes, pause, 5 flashes, pause, etc... = level 5
6 flashes, pause, 6 flashes, pause, etc... = level 6
3.To change the level, press the programme selection/cancel
button. Each time the button is pressed the level changes. (For the selection of the new level see the chart).
Examples:
if the current level is 5, by pressing programme selection/cancel
button once, level 6 is selected.
if the current level is 10, by pressing programme
selection/cancel button once, level 1 is selected.
4.To memorise the operation, switch off the dishwasher by pressing the On/Off button.