30 electrolux something not working
Something not working
The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the indications described in the chart, without calling out an engineer.
Open the door and carry out the following suggested corrective actions.
Fault code and malfunction | Possible cause and solution | |
|
| |
● continuous flashing of the light of the | ● The water tap is blocked or furred with | |
running programme, |
| limescale. |
|
| Clean the water tap. |
●intermittent audible signal,
● 1 flash of the end of programme | ● The water tap is turned off. | |
Turn the water tap on. | ||
indicator light, | ||
● The filter (where present) in the threaded | ||
| ||
The dishwasher does not fill with water | hose fitting at the water inlet valve is | |
blocked. | ||
| ||
| Clean the filter in the threaded hose. | |
| ● The water inlet hose has not been | |
| correctly laid or it is bent or squashed. | |
| Check the water drain hose connection. | |
|
| |
● continuous flashing of the light of the | ● The sink spigot is blocked. | |
running programme, | Clean out the sink spigot. | |
● intermittent audible signal, | ● The water drain hose has not been | |
● 2 flashes of the end of programme | correctly laid or it is bent or squashed. | |
Check the water drain hose connection. | ||
indicator light, | ||
| ||
The dishwasher will not drain |
| |
|
|
Remember to switch off the appliance before carrying out any corrective action.