30What to do if…
Moving the machine
If you have to move the machine (moving house etc....):
1.Unplug it.
2.Turn the water tap off.
3.Remove the water inlet and discharge hoses.
4.Pull the machine out together with the hoses. Avoid over tilting the machine during transportation.
What to do if…
The dishwasher will not start or stops during operation. Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the indications described in the chart, without calling out an engineer.
Switch off the dishwasher and carry out the following suggested corrective actions.
| Fault code and malfunction |
| Possible cause and solution | |
|
|
|
| |
• | continuous flashing of the light of the run- | • | The water tap is blocked or furred with lime- | |
| ning programme |
| scale. | |
• |
| Clean the water tap. | ||
• | appears in the digital display. | • | The water tap is turned off. Turn the water tap | |
• | intermitted audible signal |
| on. | |
The dishwasher does not fill with water. | • The filter (where present) in the threaded hose | |||
| fitting at the water inlet valve is blocked. | |||
|
|
| ||
|
|
| Clean the filter in the threaded hose. | |
|
| • | The water inlet hose has not been correctly | |
|
|
| laid or it is bent or squashed. | |
|
|
| Check the water drain hose connection. | |
|
|
|
| |
• | continuous flashing of the light of the run- | • | The sink spigot is blocked. | |
| ning programme |
| Clean out the sink spigot. | |
• |
| |||
• | The water drain hose has not been correctly | |||
• | appears in the digital display. | |||
| laid or it is bent or squashed. | |||
• | intermitted audible signal |
| Check the water drain hose connection. | |
The dishwasher will not drain. |
|
| ||
|
|
|
|