Electrolux 75011 VIL user manual Technical data, Wash results are not satisfactory

32Technical data

The wash results are not satisfactory

The dishes are not clean	•	The wrong washing programme has been se-
		lected.
	•	The dishes are arranged in such a way as to
		stop water reaching all parts of the surface.
		The baskets must not be overloaded.
	•	The spray arms do not rotate freely due to
		incorrect arrangement of the load.
	•	The filters in the base of the washing com-
		partment are dirty or incorrectly positioned.
	•	Too little or no detergent has been used.
	•	Where there are limescales deposits on the
		dishes; the salt container is empty or the in-
		correct level of the water softener has been
		set.
	•	The drain hose connection is not correct.
	•	The salt container cap is not properly closed.
The dishes are wet and dull	•	Rinse aid was not used.
	•	The rinse aid dispenser is empty.
There are streaks, milky spots or a bluish coating	•	Decrease rinse aid dosing.
on glasses and dishes
Water drops have dries onto glasses and dishes	•	Increase rinse aid dosing.
	•	The detergent may be the cause. Contact the
		detergent manufacturer’s consumer care line.

If after all these checks, the problem persists, contact your local Service Force Cen- tre.

Technical data

Dimension	Width - height - depth (cm)	59,6 x 86,8-94,8 x 55,5
Electrical connection - Voltage	Information on the electrical connection is given on the rating
- Overall power - Fuse	plate on the inner edge of the dishwasher's door
Water supply pressure	Minimum	0,05 Mpa (0,5 bar)
	Maximum	0,8 Mpa (8 bar)
Capacity	Place settings	12