Electrolux 50740 manual Pause function, Setting or changing the delay start timer

Page 27

	Operating Instructions
	Pause function
3	The pause function can only be initiated before the drying section of
	the programme I.. If the pause function is initiated during the drying

section of the programme I the wash programme is ended.

Using the pause function the dishwasher can be temporarily stopped: 0 1. Press the ON/OFF button. The wash programme will stop.

2.All indicators will go out.

3.After a short time when the wash programme is to continue, press the ON/OFF button again. The wash programme will continue.

2	The wash programme should not be stopped for a prolonged period or
	the cooled water will need to be reheated resulting in increased energy

consumption.

Setting or changing the delay start timer

Using the delay start timer you can opt to set the wash programme to start in 3, 6 or 9 hours.

0 1. Press the ON/OFF button M.

2.Setting the delay start timer:

Press the b button until the indicator next to the number of hours of delay illuminates.

Changing the delay start timer:

As long as the wash programme has not started, you can still change the delay start set by pressing the b button. Repeatedly press the b button until all three of the time indicators are off. The selected wash programme will begin immediately.

3.Press the button for the required wash programme. The programme indicator lights up.

4.After the set number of hours the wash programme will begin.

Load Sensing – Sensor Logic

If a wash programme is started even though there are only a few dishes in the upper and/or lower basket, an intelligent electronic system adjusts the amount of water and the duration of the wash programme to the number of dishes. By this means it is possible to wash only a few dishes quickly and economically. At half load (6 place settings), up to 2 litres of water and 0.2 kWh of electricity are saved.

27

Image 27

Contents Favorit Pass them on to any subsequent owner of the appliance Tips on using the applianceDear customer Please read these user instructions carefullyContents Installation and Connection Instructions General Safety Safety InstructionsInstallation, Connection and Placing into Operation Child SafetyCorrect Use Disposal of Old Appliances DisposalEconomical and Ecological Dishwashing Disposing of the Packaging MaterialAppliance Features and Control Panel Ning Control panelPanel Prior to using for the first timeAdjust the water softener Your areaIng the appropriate button Dishwasher must be switched offManual setting Electronic settingTurning it anticlockwise Filling with Salt for the Water SoftenerFill with dishwasher salt Remain illuminated Open the door, remove the lower BasketTo switch off the control indicator for rinse aid Rinse aidRinse aid can be added in one of two ways Fully open the rinse aid compartment lid Filling with rinse aidDaily Use Adjusting Rinse Aid DosingNot be washed in the dishwasher Loading Cutlery and DishesLoading Cutlery Two right-hand plate inserts Loading Pans, Frying Pans Large PlatesFolded over to the left To ease the loading of large itemsBaskets can be folded across one another Folded across one anotherAcross one another Two rear plate inserts in the lowerLoading Cups, Glasses and Coffee Services Adjusting the Height of the Upper Basket Lowering the Upper BasketRaising the Upper Basket Fill with detergent Filling with DetergentGeneral Advice Special AdviceUse of 3 in 1/ Combi Detergent Tablets Detergent tablets Concentrated DetergentAddition Selecting the Wash Programme Programme TableOpen the door carefully Start the wash programmeInterrupting or ending the wash programme WasherPause function Setting or changing the delay start timerSetting the delay start timer Changing the delay start timerEmptying the Dishwasher Care and CleaningSwitching Off the Dishwasher Sive cleanersStances Cleaning the FilterWhat to do, if Fault warnings are displayedDishes are wet and dull There are problems with the operation of the dish- washerWash results are not satisfactory Dishes are still dirtyTechnical Data Lower rinse aid dosingThere are dried water drops on the glasses and dishes Upper basket Lower basket with cutlery basket Sample loading arrangementsFree-Standing Appliances Installing the DishwasherSee enclosed installation instructions Built-Under DishwasherWork surface must be re-mounted Plinth on free-standing appliances is not adjustableConnect the inlet hose Connecting the DishwasherWater Connection Permitted water pressurePlease take care when installing the water inlet hose Water inlet hose with safety valveWater drain Appliance is automatically pumped out Leak Prevention SystemChanging a fuse Electrical ConnectionConnections Guarantee Conditions 08705 929 Customer CareCalls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG