Electrolux 50740 manual Electrical Connection, Changing a fuse

Page 40

Installation and Connection Instructions

Electrical Connection

 

Any electrical work required to install this appliance should be car-

 

ried out by a qualified electrician or competent person.

1

WARNING - This appliance must be earthed.

 

The manufacturer declines any responsibility should these safety

measures not be observed.

Before switching on make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.

To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.

Changing a fuse

The appliance is supplied with a 13amp plug fitted. In the event of hav- ing to change the fuse in the plug supplied, a 13amp ASTA approved (BS 1363A) fuse must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires on the mains lead are coloured in accordance with the following code.

Green

& Yellow

BlueBrown

Green and Yellow : Earth

Blue

: Neutral

Brown

: Live

Cord Clamp

The wire coloured green and yellow must be connected to the termi-

nal marked with the letter “E“ or by the earth symbol or coloured green and yellow.

The wire coloured blue must be connected to the terminal “N“ or col- oured black.

The wire coloured brown must be connected to the terminal marked “L“ or coloured red.

Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

1WARNING! A cut off plug inserted into a 13 amp socket is a seri- ous safety (shock) hazard. Ensure that, if it is necessary to cut off the plug, it is disposed of safely and not retained.

40

Image 40
Contents Favorit Tips on using the appliance Dear customerPlease read these user instructions carefully Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions Safety Instructions Installation, Connection and Placing into OperationChild Safety General SafetyCorrect Use Disposal Economical and Ecological DishwashingDisposing of the Packaging Material Disposal of Old AppliancesAppliance Features and Control Panel Control panel NingPrior to using for the first time Adjust the water softenerYour area PanelDishwasher must be switched off Manual settingElectronic setting Ing the appropriate buttonFilling with Salt for the Water Softener Fill with dishwasher saltRemain illuminated Open the door, remove the lower Basket Turning it anticlockwiseRinse aid To switch off the control indicator for rinse aidRinse aid can be added in one of two ways Filling with rinse aid Fully open the rinse aid compartment lidAdjusting Rinse Aid Dosing Daily UseLoading Cutlery and Dishes Not be washed in the dishwasherLoading Cutlery Loading Pans, Frying Pans Large Plates Folded over to the leftTo ease the loading of large items Two right-hand plate insertsFolded across one another Across one anotherTwo rear plate inserts in the lower Baskets can be folded across one anotherLoading Cups, Glasses and Coffee Services Lowering the Upper Basket Adjusting the Height of the Upper BasketRaising the Upper Basket Filling with Detergent Fill with detergentSpecial Advice General AdviceUse of 3 in 1/ Combi Detergent Tablets Concentrated Detergent Detergent tabletsSelecting the Wash Programme Programme Table AdditionStart the wash programme Interrupting or ending the wash programmeWasher Open the door carefullySetting or changing the delay start timer Setting the delay start timerChanging the delay start timer Pause functionCare and Cleaning Switching Off the DishwasherSive cleaners Emptying the DishwasherCleaning the Filter StancesFault warnings are displayed What to do, ifThere are problems with the operation of the dish- washer Wash results are not satisfactoryDishes are still dirty Dishes are wet and dullLower rinse aid dosing Technical DataThere are dried water drops on the glasses and dishes Sample loading arrangements Upper basket Lower basket with cutlery basketInstalling the Dishwasher See enclosed installation instructionsBuilt-Under Dishwasher Free-Standing AppliancesPlinth on free-standing appliances is not adjustable Work surface must be re-mountedConnecting the Dishwasher Water ConnectionPermitted water pressure Connect the inlet hoseWater inlet hose with safety valve Please take care when installing the water inlet hoseWater drain Leak Prevention System Appliance is automatically pumped outElectrical Connection Changing a fuseConnections Guarantee Conditions Customer Care 08705 929Calls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG