Electrolux 50740 manual Water inlet hose with safety valve

Page 37

 

Installation and Connection Instructions

3

The following section is only applicable to dishwashers that have a

 

safety valve on the threaded hose fitting for the tap:

 

Water inlet hose with safety valve

 

After connecting the double-walled water inlet hose, the safety valve is

 

next to the tap. Therefore the water inlet hose is only under pressure

 

while the water is running. If the water inlet hose starts to leak during

 

this operation, the safety valve cuts off the running water and the

 

draining pump in the dishwasher is switched on.

1

Please take care when installing the water inlet hose:

 

– The distance between the bottom

 

edge of the safety value and the

 

floor on which the dishwasher is

 

standing must be at least 30 cm:

 

– The electrical cable for the safety

 

valve is in the double-walled water

 

inlet hose. Do not immerse the

 

water inlet hose or the safety valve

 

in water.

 

– If the water inlet hose or the safety

 

valve is damaged, remove the

 

mains plug immediately.

 

– A water inlet hose with safety valve

 

must only be replaced by your local

 

Service Force Centre.

 

– Place the water inlet hose in such a way that it is never higher than

 

the bottom edge of the safety valve.

37

Image 37
Contents Favorit Dear customer Tips on using the appliancePlease read these user instructions carefully Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions Installation, Connection and Placing into Operation Safety InstructionsChild Safety General SafetyCorrect Use Economical and Ecological Dishwashing DisposalDisposing of the Packaging Material Disposal of Old AppliancesAppliance Features and Control Panel Ning Control panelAdjust the water softener Prior to using for the first timeYour area PanelManual setting Dishwasher must be switched offElectronic setting Ing the appropriate buttonFill with dishwasher salt Filling with Salt for the Water SoftenerRemain illuminated Open the door, remove the lower Basket Turning it anticlockwiseRinse aid To switch off the control indicator for rinse aidRinse aid can be added in one of two ways Fully open the rinse aid compartment lid Filling with rinse aidDaily Use Adjusting Rinse Aid DosingNot be washed in the dishwasher Loading Cutlery and DishesLoading Cutlery Folded over to the left Loading Pans, Frying Pans Large PlatesTo ease the loading of large items Two right-hand plate insertsAcross one another Folded across one anotherTwo rear plate inserts in the lower Baskets can be folded across one anotherLoading Cups, Glasses and Coffee Services Lowering the Upper Basket Adjusting the Height of the Upper BasketRaising the Upper Basket Fill with detergent Filling with DetergentSpecial Advice General AdviceUse of 3 in 1/ Combi Detergent Tablets Detergent tablets Concentrated DetergentAddition Selecting the Wash Programme Programme TableInterrupting or ending the wash programme Start the wash programmeWasher Open the door carefullySetting the delay start timer Setting or changing the delay start timerChanging the delay start timer Pause functionSwitching Off the Dishwasher Care and CleaningSive cleaners Emptying the DishwasherStances Cleaning the FilterWhat to do, if Fault warnings are displayedWash results are not satisfactory There are problems with the operation of the dish- washerDishes are still dirty Dishes are wet and dullLower rinse aid dosing Technical DataThere are dried water drops on the glasses and dishes Upper basket Lower basket with cutlery basket Sample loading arrangementsSee enclosed installation instructions Installing the DishwasherBuilt-Under Dishwasher Free-Standing AppliancesWork surface must be re-mounted Plinth on free-standing appliances is not adjustableWater Connection Connecting the DishwasherPermitted water pressure Connect the inlet hosePlease take care when installing the water inlet hose Water inlet hose with safety valveWater drain Appliance is automatically pumped out Leak Prevention SystemChanging a fuse Electrical ConnectionConnections Guarantee Conditions Customer Care 08705 929Calls may be recorded for training purposes AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG