Electrolux Santo 1573TK-4 operating instructions What to do if

Page 21

What to do if ...

Malfunction

The food is too warm.

Interior lighting does not work.

Heavy build up of frost, possibly also on the door seal.

Possible Cause

Temperature is not properly adjusted.

Door was open for an extended period.

A large quantity of warm food was placed in the appliance within the last 24 hours.

The appliance is near a heat source.

Light bulb is defective.

Door seal is not air tight (possibly after changing over the hinges).

Remedy

Please look in the "Initial Start Up" section.

Open the door only as long as necessary.

Turn the temperature regulator to a colder setting temporarily.

Please look in the "Installation location" section.

Please look in the "Changing the Light Bulb" section.

Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than approx. 50 °C). At the same time shape the warmed door seal by hand such that it sits correctly.

 

 

Appliance is not level.

 

Readjust the feet.

 

 

 

 

 

 

 

The appliance is touching

 

Move the appliance

 

 

the wall or other objects.

 

slightly.

Unusual noises.

 

 

 

 

 

A component, e.g. a pipe,

 

 

 

 

on the rear of the

 

If necessary, carefully

 

 

appliance is touching

 

bend the component out

 

 

another part of the

 

of the way.

 

 

appliance or the wall.

 

 

 

 

 

 

 

 

 

 

 

 

The compressor does not

 

 

 

 

start immediately after

 

This is normal, no error has

 

The compressor starts

changing the temperature

 

occurred.

 

after a period of time.

setting.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Water on the floor or on

 

Water drain hole is

 

See the "Cleaning and

storage shelves.

 

blocked.

 

Care" section.

 

 

 

 

 

21

Image 21
Contents ÖKO-SANTO Super Dear customer Contents Safety of children SafetyIntended use Prior to initial start-upCase of malfunction Daily OperationDisposal Remove transport safeguardAppliance Packaging Information Disposal of old AppliancesInstallation Location InstallationSpecial accessories Your refrigerator needs airDetaching the worktop Rehingeing the door Mounting under a continuous worktopOpen the freezer compartment door a little way Changing over the freezer compartment doorElectrical Connection Prior to Initial Start-UpSetting „0 means Off Starting up and temperature regulationSetting „1 means Plug socketStorage shelves/wire trays Interior AccessoriesVario glass storage shelf Correct storageTips Freezing and storing frozen foodDefrosting Preparation of Ice CubesFridge defrosts automatically Defrosting the freezer compartmentSwitching off the appliance Cleaning and Care Energy Saving Tips Correcting Malfunctions What to do ifWhat to do if Changing the light bulb Regulations, Standards, Guidelines Customer Service