Electrolux Santo 1573TK-4 operating instructions Prior to Initial Start-Up, Electrical Connection

Prior to Initial Start–Up

0Please clean the appliance interior and all accessories prior to initial start-up (see section: “Cleaning and Care”).

Electrical Connection

Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.

1WARNING – THIS APPLIANCE MUST BE EARTHED

The manufacturer declines any liability should these safety measures not be observed.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is inside, on the left.

The appliance is supplied with a 13 amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used.

Important

The wires in the mains lead are coloured in accordance with the following code:

Green and YellowEarth Blue Neutral BrownLive

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings indentifying the terminals in your plug, proceed as follows:

1.The wire coloured green and yellow must be connected to the terminal marked with the letter „E“ or by the earth symbol or coloured green and yellow.

2.The wire coloured blue must be connected to the terminal „N“ or coloured black.

3.The wire coloured brown must be connected to the terminal marked „L“ or coloured red.

4.Upon completion there must be not cut, or stray strands of wire present and the cord clamp must be secure over the outer sheat.

1Warning! A cut-off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut-off plug is disposed of safely.

11