Installation

Problem

electrolux 27

Possible Solution

The grill does not work or cuts out after being used for a long period of time.

The indicator neons are not work- ing correctly.

The oven is not cooking evenly.

The oven light fails to illuminate.

The oven fan is noisy.

The oven temperature is too high or too low.

If you have checked the above: Allow the appliance to cool for a couple of hours. The appliance should now be working normally.

Ensure the cooling fan is running when the grill is on. If the cooling fan fails, the grill will not operate correctly. Contact your local serv- ice force centre.

Leave the grill door open and allow the grill to cool. After a couple of hours check that the grill works as normal

Check that you have selected only the function you require. Ensure all other controls are in the off position.

Check that the appliance is correctly installed and is level.

Check that the recommended temperatures and shelf positions are being used.

The oven light bulb may need replacing.

Check that the oven is level.

Check that the shelves and bakeware are not vibrating in contact with the oven back panel.

Check that the recommended temperatures and shelf positions are being used. Be prepared to adjust the temperature up or down slightly to achieve the results you want.

•The set-up of the electrical installation is arranged so that the appliance can be iso- lated from the mains with a minimum 3 mm all-pole contact separation.

Suitable isolation devices include, for ex- ample, circuit breakers, fuses (screw type fuses are to be removed from the holder), RCDs and contactors.

•Anti-shock protection must be provided by the installation.

•The built-in unit must meet the stability re- quirements of DIN 68930.

•Built-in cookers and cooking surfaces are equipped with special attachment sys-

tems. For safety reasons, they must only be combined with appliances from the same manufacturer.

The use of heat protection strips is prohibited for cookers and ovens with Pyrolytic Clean- ing, if the recess has a rear wall and closed ground-level compartment.

However installation is possible with a ground-level compartment that has been shortened by at least 20 mm and which has base ventilation of the same cross-section.