Electrolux 130 FG-m manual

Page 19

Mounting of attachment fitting on the sides of the combi-grill

If the appliance is mounted in a 270 X 490 mm cutout, or if for other reasons there is no room for the side attachments, these should be removed before the appliance is set into the worktop.

Set the appliance into the worktop and then raise it enough to expose the screws in the sides.

Remove the screws.

Mount the attachment fittings so that they interlock with the frame (See illustration).

Reinsert the screws in the sides through the oblong hole in the fitting.

Set the appliance into the worktop and tighten the attachment fittings.

19

Image 19

Contents Instruction Book Your New Appliance Table of contents Safety rules Safety informationInstalling Before using the applianceDuring use Child safetyMaintenance and cleaning ServiceDescription of the appliance Grilling Operating instructionsOperation of the grill Control lampOverheating protection FryingGrilling over water Tips on grillingUse of the grill Grilling over lava blocksFoods Heat setting Cooking time in minutes Tips on frying Foods Amount Temperature Time min Dinner is now ready to be served Splashguard Maintenance and cleaningLava stones Stainless steel surfacesGrill Grill gridFrying container Draining of the oilUnpacking Technical dataMounting of Reinforcement Beams InstallationFixing Cut-out measurementsPage Units externally measured length Electrical installation Something not working Solution08705 929 Service & spare partsEuropean guarantee Guarantee conditionsFrance Page Page 325 88-4731 Rev. B-049