Electrolux Oven brochure Electrical Connection, Connecting the Terminal Board

ELECTRICAL CONNECTION

Prior to making the electric al connection, make sure that:

-The protection fuse and the domestic wire system are suitable to carry the total electric load of the oven (see rating plate).

-Your domestic wiring system has an efficient earth connection in compliance with the rules and laws in force.

-The wall socket or the omnipole switch used for the electrical connection can easily be reached after the oven is built in.

The appliance is delivered without an electric supply cable, therefore, you will have to fit to it a supply cable with standard plug, suitable for the total electric load shown on the rating plate.

The plug is to be inserted into a suitable wall socket. If you require a direct connection to the electric network (mains), it will be necessary to fit between the appliance and the mains an omnipole switch, aith a minimum gap between contacts of 3 mm. suitable for the required load and in compliance with rules in force. The green 1 yellow ground wire must not be interrupted by the switch.

The supply cable must in all cases be laid out in such a way as to ensure that it does not reach at any given point a temperature 50°C higher than the ambient tem- perature.

The manufacturer disclaims any liability in case these accident-preventing rules are not observed.

Suitable power supply cables are the following types, considering the respective necessary section of cable.

•H07 RN-F

•H05 RN-F

•H05 RR-F

•H05 VV-F

CONNECTING THE TERMINAL BOARD

The appliance incorporates an easily accessible 6- pole terminal board whose jumpers (bridges) are already pre-set for operation on 230 V single-phase (Fig. 19). In case where different mains voltage is present, the jumpers on the terminal board must be arranged as shown in the diagram (Fig. 20).

The ground cable must be connected to terminal .

After connecting the supply cable to the terminal board, secure it with a junction clamp.

	FO 0330									Fig. 19
1		2	3		4 5					Section
	230V 3~									of cable
										(min.)
	L1			L2		L3 PE				4 x 1.5 mm2
1		2	3		4 5					Section
	230V 1~									of cable
										(min.)
	L1				N		PE			3 x 2.5 mm2
	1	2	3		4 5					Section
	400V 2N~									of cable
										(min.)
	L1 L2				N			PE		4 x 2.5 mm2
1		2	3		4 5					Section
	400V 3N~									of cable
										(min.)
	L1 L2 L3 N								PE	5 x 1.5 mm2

FO 0584-EN

Fig. 20

77