Self-Clean Cycle
To start the Self-Clean cycle:
1. | Close the door completely. |
2. | Turn the oven selector knob clockwise to the “SELF CLEAN” mode. |
3. | Turn the temperature control knob past the clean setting until the |
| knob stops. At this time, the clean indicator light will come on. |
| Within 30 seconds the automatic door latch engages and the oven |
| indicator light comes on. The oven indicator light will remain on |
| until the oven reaches the |
| on and off during the |
| elevated temperature needed for |
| light comes on. |
4. | The door lock indicator light will remain on until the |
| completed or interrupted and the oven temperature drops to a safe |
| temperature. A complete cycle is approximately |
Replacing Oven Lights
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect the electric power at the main fuse or circuit breaker before replacing bulb.
WARNING
DO NOT touch bulb with bare hands. Clean off any signs of oil from the bulb and handle with a soft cloth.
DO NOT touch bulb with bare hands. Clean off any signs of oil from the bulb and handle with a soft cloth.
additional 30 minutes needed for the oven to cool down enough |
for the door latch to disengage. |
Note: A fan noise will be heard during the |
continue to run for the |
Note: On griddle model ranges, the griddle/simmer plate will not |
function during the |
5. When the cycle is completed, turn both the oven selector and |
temperature control knob to the “OFF” position. When the oven |
has completely cooled, open door and remove any ash from the |
oven surfaces with a damp cloth. |
To stop the Self-Clean cycle:
To cancel or interrupt the
Product Care
1.Unsnap glass light cover using a screwdriver in the access groove.
2.Firmly grasp light bulb and pull out.
3.Replace with halogen bulb using volt and wattage requirements listed on glass cover.
4.Replace the light cover by snapping glass cover onto metal box.
5.Reconnect power at the main fuse or circuit breaker.
access groove
light bulb
glass light
cover
Product Care
48 | 49 |