Viking 15" W installation instructions Final Preparation, Service Information

Page 19

FINAL PREPARATION

1.Some stainless steel parts may have a plastic protective wrap which must be peeled off. The interior of the ice machine should be washed thoroughly with hot, soapy water, rinsed and wiped dry to remove film residue and any installation dust or debris before being used. Solutions stronger than soap and water are rarely needed.

2.All stainless steel parts should be wiped with hot soapy water. If buildup occurs, do not use steel wool, abrasive cloths, cleaners, or powders. If it is necessary to scrape stainless steel to remove encrusted materials, soak with hot, wet cloths to loosen the material, then use a wood or nylon scraper. Do not use a metal knife, spatula, or any other metal tool to scrape stainless steel; scratches are almost impossible to remove.

SERVICE INFORMATION

It is assumed that your ice machine has been properly installed in accordance with all specifications and local codes and the appliance has been properly grounded. If your ice machine should fail to operate, review the troubleshooting chart before calling for service.

If service is required:

1.Call your dealer or authorized service agency. The name of the authorized service agency can be obtained from the dealer or distributor in your area.

2.Have the following information readily available:

•Model number •Serial number •Date of purchase

•Name of dealer from whom purchased

If you are unable to obtain the name of an authorized service agency, or if you continue to have service problems, contact Viking Range Corporation at (888) 845-4641 or write to:

VIKING RANGE CORPORATION

PREFERRED SERVICE

111 Front Street

Greenwood, Mississippi 38930 USA

Record the following information indicated below. You will need it if service is ever required. The serial number and model number for your ice machine is located on the front of the unit at the base of the door frame.

Model Number

 

Serial Number

 

Date of Purchase

 

Date Installed

 

Dealer’s Name

 

 

 

 

Address

 

 

 

 

If service requires installation of parts, use only authorized parts to ensure protection under the warranty.

This manual should remain with the ice machine for future reference.

19

Image 19
Contents Important Please Read and Follow For Your SafetyProper Disposal of Your OLD Refrigeration Product Area Requirements General InformationUndercounter Cabinet Cutout UnpackSide View SPECIFICATIONS/DIMENSIONSFront View Professional Models Vuim37 9/16 95.4 cm 22 55.9 cm 24 5/8 62.6 cm 25 5/8 65.1 cm SPECIFICATIONS/DIMENSIONS Designer ModelDuim DfimBottom View of Door with Left Hand Swing Full Overlay Panel Installation14 3/4 37.5 cm 15/16 22.7 cm TYP 13/16 14.8 cm Selecting and Preparing the Overlay Panel Dfim ModelsAttaching the Overlay Panel to the Door Hinge Hardware Installation DetailsLEG Leveler Installation Read Before Installing LEG Levelers Electrical Connection Wiring Diagram Undercounter 15 W. ICE MachineWater Supply Water ConnectionModel Number VUIM-DP Drain PlumbingGravity Drain Gravity Drain Location Drain PumpIce Machine Safety and Operation Tips ICE Machine FeaturesHOW the ICE Machine Works Cleaning and Maintenance Using Your ICE MachineOutdoor Use Cleaning the ICE Machine System Preparing the ICE Machine for Storage Troubleshooting GuideRoom and/or water temperature Ice machine selector switch isSelector switch is in the OFF Or Clean positionNot enough water in reservoir Room temperature is too warmIce cubes are too small Low ice consumption Less than 1/2 thickLow ice production. Unit Low water level in reservoir Grid cutter is not cutting Selector switch is notRoom temperature is too cold AdjustingFinal Preparation Service InformationUnits certified for Indoor Use UNDERCOUNTER/FREESTANDING ICE Machine WarrantyUnits certified for Outdoor Use