FULL OVERLAY PANEL INSTALLATION
Note: Weight of wood panel must not exceed 20 lbs.
Wood Screws
1.A #8 pan head wood screw should be used to properly secure the wood panel. A total of 8 screws will be needed.
2.Only use pan head screws.
3.DO NOT select a screw that is longer than the wood thickness at
the screw locations. |
| Working Material | Wood Screw Size #8 |
|
4. Use recommended pilot holes for the frame material. (See chart) |
| Hardwood | 3/32 (0.24 cm) |
|
|
| Softwood | 5/64 (0.20 cm) |
|
|
|
|
|
|
Assembling Door Hinge Brackets
(Disregard if hinge brackets are already attached)
1.Attach the top and bottom door hinge brackets to the door with the
2.Press in the shoulder bushings to the top and bottom door hinge brackets. Make certain that the shoulder is to the outside of the door as shown in Figure 1 below.
3.Test fit the door to the unit to make certain door will hang correctly. The door is hung correctly when the top of the door is parallel to the top of the unit. Adjustments can be made by loosening the door hinge machine screws and moving the door hinge brackets on the door.
4.Tighten all four (4) machine screws after adjustments have been made.
5. Remove the door from the unit by removing the units top hinge set screw and angling the door off of the bottom hinge pin.
Screw
Door Hinge
Screw Holes
FIGURE 1
Typical Top and Bottom Door
Hinge Bracket Assembly
Door Front Surface
FRONT
Bottom View of Door with Left Hand Swing
5