Viking 15" W General Information, Undercounter Cabinet Cutout, Unpack, Area Requirements

Page 2

GENERAL INFORMATION

Unpack

1.Remove banding from bottom of carton. Lift carton up and off of the ice machine

2.Remove all tape and packaging material from the outside and inside of the cabinet.

3.Keep all carton packaging until your ice machine has been thoroughly inspected and found to be in good condition.

Area Requirements

1.Place unit so the front side will be completely unobstructed to provide proper air flow. The unit may be closed in on the top and three sides, but the front MUST BE unobstructed for air circulation and proper operation. Installation should be such that the cabinet can be moved for servicing if necessary.

2.Unit should be in a well ventilated area. Best results are obtained at temperatures between 550F (130C) and 800F (270C) for built-in indoor models, between 550F (130C) and 900F (320C) for indoor freestanding models, and between 450F (7.20C) and 1100F (430C) for outdoor models.

3.Provisions for electricity should be determined before placing unit in proper place.

4.For best performance, outdoor units should be installed away from direct sunlight or under a counter or sink.

UNDERCOUNTER CABINET CUTOUT

 

A

 

15”

(38.1 cm)*

 

 

 

 

 

B

 

Min. 34 1/2” (87.6 cm)

 

 

 

 

Max. 35 1/8” (89.2 cm)

 

 

C

 

24”

(61.0 cm)

 

 

 

 

 

 

 

*15” (38.1 cm) width for cabinet only. If door is recessed between cabinets, cabinet cutout must be 15-1/4” (38.7 cm.).

A

B

C

2

Image 2
Contents Proper Disposal of Your OLD Refrigeration Product For Your SafetyImportant Please Read and Follow Unpack General InformationUndercounter Cabinet Cutout Area RequirementsProfessional Models Vuim SPECIFICATIONS/DIMENSIONSFront View Side ViewDfim SPECIFICATIONS/DIMENSIONS Designer ModelDuim 37 9/16 95.4 cm 22 55.9 cm 24 5/8 62.6 cm 25 5/8 65.1 cmFull Overlay Panel Installation Bottom View of Door with Left Hand SwingSelecting and Preparing the Overlay Panel Dfim Models 14 3/4 37.5 cm 15/16 22.7 cm TYP 13/16 14.8 cmHinge Hardware Installation Details Attaching the Overlay Panel to the DoorLEG Leveler Installation Read Before Installing LEG Levelers Wiring Diagram Undercounter 15 W. ICE Machine Electrical ConnectionWater Connection Water SupplyDrain Pump Drain PlumbingGravity Drain Gravity Drain Location Model Number VUIM-DPHOW the ICE Machine Works ICE Machine FeaturesIce Machine Safety and Operation Tips Outdoor Use Using Your ICE MachineCleaning and Maintenance Cleaning the ICE Machine System Troubleshooting Guide Preparing the ICE Machine for StorageOr Clean position Ice machine selector switch isSelector switch is in the OFF Room and/or water temperatureLess than 1/2 thick Room temperature is too warmIce cubes are too small Low ice consumption Not enough water in reservoirAdjusting Grid cutter is not cutting Selector switch is notRoom temperature is too cold Low ice production. Unit Low water level in reservoirService Information Final PreparationUNDERCOUNTER/FREESTANDING ICE Machine Warranty Units certified for Indoor UseUnits certified for Outdoor Use