![](/images/new-backgrounds/1051072/5107211x1.webp)
Clean Before Using
After you remove all of the package materials, clean the inside of your refrigerator before using it. See the cleaning instructions in “Refrigerator Care.”
Important information to know about glass shelves and covers:
Do not clean glass shelves or covers with warm water when they are cold. Shelves and covers may break if exposed to sudden temperature changes or impact, such as bumping. For your protection, tempered glass is designed to shatter into many small,
Install Custom Overlay Panel
IMPORTANT:
■Create custom overlay panel according to the specifications in the “Custom Overlay Panel” section.
■KitchenAid is not responsible for the removal or addition of molding or decorative panels that would not allow access to the refrigerator for service.
Remove the Door
IMPORTANT: Do not remove the grease from the washer, top spacer or top hinge pin. Be sure to set aside the top hinge, top spacer and washer for later use.
1.Using a Phillips screwdriver, remove the three screws from the top hinge. Remove the top hinge.
A |
B
C
D
E
A. Screws (3)
B. Top hinge
C.Washer
D.Top spacer
E.Door
2.Remove the three screws from the top spacer. Remove the top spacer and washer.
3.Open the door. Lift the front of the door up, pulling straight out to remove as shown.
Attach the Overlay Panel
NOTE: If the overlay hooks are not installed, see “Custom Overlay Panel” for overlay hook locations.
1.Position the overlay panel ¹⁄₂" (1.27 cm) higher than the door. Be sure to position the overlay hooks to the pilot holes.
2.Insert the overlay hooks into the top of the holes in the door. Push against the overlay panel to force the overlay hooks deeper into the door. Pull the overlay panel straight down to secure the overlay hooks to the door.
3.Using a Phillips screwdriver, attach the overlay plates to the bottom of the overlay panel and door as shown.
AB C D
A. Overlay panel
B.Door
C.Overlay plates (2)
D.
6