KitchenAid 2313684A manual Vacation and MovingCare, To shut down the ice maker

Page 11

10.Remove, clean and replace the ice scoop and ice scoop holder.

■After removing the ice scoop, remove the holder by removing the two thumb screws.

■Wash the ice scoop holder along with the other interior components using the following instructions.

■Replace the ice scoop holder by replacing the thumb screws.

A

B

A. Thumb screw

B. Ice scoop holder

11.Wash the interior components (cutter grid, exterior of hoses, and water pan) and the storage bin, door gasket, ice scoop, and ice scoop holder with mild soap or detergent and warm water. Rinse in clean water. Then clean the same parts with a solution of 1 tbs (15 mL) of household bleach in 1 gal. (3.8 L) warm water. Rinse again thoroughly in clean water.

NOTE: Do not remove hoses. Do not wash plastic parts in dishwasher. They cannot withstand temperatures above 145°F (63°C).

12.Replace water pan by pushing back on the bottom with one hand while pushing up and back on the top. Secure the water pan by replacing both screws.

13.Replace the water pan drain pump by aligning the slots in the water pan to the tabs in the pump. Push the pump and the water pan together, then rotate the pump one-quarter turn.

14.Check the following:

■Drain cap from the water pan is securely in place. If the drain cap is loose, water will empty from the water pan, and you will have either thin ice or no ice.

■Hose from water pan is inserted into storage bin drain opening.

■Be sure that the water pan drain pump is fully inserted into the water pan. If the pump is loose, water will empty from the water pan and cause poor or no ice production.

15.Slide the cutter grid back into place and secure it by replacing the right-hand screw and plastic spacer. Then tighten the left-hand screw. Reconnect the cutter grid harness and the ice level sensor harness.

16.Replace the cutter grid cover and the two screws.

17.Plug in ice maker or reconnect power.

Vacation and MovingCare

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

To shut down the ice maker:

1.Unplug ice maker or disconnect power.

2.Remove all ice from storage bin.

3.Shut off the water supply.

4.Remove the two screws in the lower access panel and the two screws from the base grille area of the front panel support. Pull forward to remove the lower access panel.

5.Disconnect the inlet and outlet lines to water valve. Allow these lines to drain and then reconnect to the valve.

6.Replace lower access panel and screws.

7.Drain water from water pan by removing the drain cap.

8.If the room temperature will drop below 32°F (0°C), remove water from the drain line.

For ice makers with a drain pump installed:

■Plug in ice maker or reconnect power.

■Turn ice maker off and remove all remaining ice from ice bin.

■Pour 1 qt (0.95 L) of water into the ice bin near the drain and let the unit stand for approximately 5 minutes. This will allow the water in the bin to drain into the drain pump so that the pump will remove the remaining water from the ice bin and the drain pump.

■Unplug ice maker or disconnect power.

9.Before using again, clean the ice maker and storage bin.

10.Plug into a grounded 3 prong outlet.

NOTE: All components of the ice maker are permanently lubricated at the factory. They should not require any additional oiling throughout the normal life of the machine.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents ICE Maker Table of Contents/Table des matièresTable DES Matières Table of ContentsUnpack the Ice Maker ICE Maker SafetyInstallation Instructions Cleaning Before UseRecommended grounding method Location RequirementsElectrical Requirements Water Supply RequirementsTools needed Connecting the water lineLeveling ConnectWater SupplyGravity Drain System Connecting the DrainDrain Connection Drain Pump System on some modelsIce Maker Door Reverse Door Catch ICE Maker USENormal Sounds How Your Ice Maker WorksICE Maker Care Usingthe ControlsCleaning Dirty or clogged condenser CondenserInterior Components To shut down the ice maker Vacation and MovingCareIce Production TroubleshootingIce Maker Operation U.S.A Assistance or ServicePlumbing Problems Ice QualityDisclaimer of Implied Warranties Limitation of Remedies Kitchenaid ICE Maker WarrantyONE Year Limited Warranty Items Kitchenaid will not PAY forEnlèvement des matériaux d’emballage Instructions D’INSTALLATIONSécurité DE LA Machine À Glaçons Déballage de la machine à glaçonsSpécifications de l’alimentation en eau Exigences demplacementMéthode de mise à la terre recommandée SpécificationsélectriquesOutils requis NivellementRaccordement à lacanalisation d’eau Outillage nécessaireVUE Arrière Raccordementau conduit dévacuationVidange par gravité Dépose de la porte Porte de la machine à glaçonsSystème avec pompe de vidange sur certains modèles Raccordement du conduit dévacuationCharnière supérieure Réinstallation de la porteSons normaux Inversion des charnières Inversion du loquet de porteFonctionnement dela machine à glaçons Utilisation des commandesHoliday Mode mode vacances Utilisation DE LA Machine À GlaçonsNettoyage Entretien DE LA Machine À GlaçonsVis de serrage Support de pelle à glace Composants intérieursArrêt de la machine à glaçons Précautions à prendre avant lesvacances Ou déménagementLa machine à glaçons semble bruyante DépannageProduction deglaçons La machine à glaçons ne fonctionne pasProblèmes deplomberie Assistance OU ServiceQualité des glaçons Kitchenaid NE Prendra PAS EN Charge Garantie DE LA Machine À Glaçons KitchenaidGarantie Limitée DE UN AN All rights reserved 2313684A

2313684A specifications

The KitchenAid 2313684A is a versatile and powerful addition to any kitchen, designed to cater to the needs of home cooks and professional chefs alike. This model stands out with its exceptional design and array of features that enhance the cooking experience.

One of the main highlights of the KitchenAid 2313684A is its robust construction. Built to last, it combines a stainless steel body with a powerful motor that ensures durability and resilience. The elegant design not only makes it aesthetically pleasing but also easy to clean, maintaining its polished look after numerous culinary adventures.

The 2313684A is equipped with a variety of attachments, enabling users to perform multiple functions in the kitchen. From mixing and kneading to whipping and pounding, this device eliminates the need for various gadgets, as it can handle a range of tasks with ease. This feature is especially useful for those who wish to streamline their kitchen tools without sacrificing functionality.

Another significant feature is the variable speed control. Users can choose from multiple speeds, allowing for precise mixing according to individual recipes and preferences. This flexibility is essential when dealing with different ingredients, ensuring perfect results whether making delicate meringues or robust bread doughs.

The KitchenAid 2313684A also embraces modern technology with its ergonomic design, which provides a comfortable grip and usability. The bowl-lift mechanism allows for easy access to ingredients and the ability to work with larger batches, making it a practical choice for larger households or those who like to entertain.

Safety is integral to KitchenAid's philosophy, and the 2313684A incorporates various safety measures, including a locking mechanism during operation. This feature provides peace of mind, allowing users to focus on their culinary creations without worrying about accidental mishaps.

Moreover, KitchenAid offers a range of color options for the 2313684A, allowing customers to choose a model that matches their kitchen decor and personal style. This attention to detail ensures that the appliance not only performs well but also complements the overall aesthetic of the kitchen.

In conclusion, the KitchenAid 2313684A combines power, versatility, and style, making it an indispensable tool for any cooking enthusiast. Its high-quality construction, numerous attachments, variable speed options, and safety features set it apart in the competitive market of kitchen appliances, ensuring that it meets the demands of both casual cooks and seasoned professionals. Whether you’re baking a cake, whipping cream, or kneading dough, the KitchenAid 2313684A is designed to make the process efficient and enjoyable.
Top Page Image Contents