KitchenAid KUDC25CH, KUDS25SH manual Canceling a Cycle, To stop the drain, To clear the indicators

		Use this cycle for loads					Use both
		with normal amounts of					detergent
		food soil. (The energy-					dispenser
		usage label is based on					sections.
		this cycle.)
Soil	Pre-		Rinse	Main	Rinse	Final	Dry	Time	Water
Level	Wash			Wash	or	Heated		(min)	Usage
Sensed					Purge†	Rinse			(gal/L)
	●		●	●	●	●	●	88*	10.8/
Heavy				140°F		140°F			40.9
				(60°C)		(60°C)
	●			●	●	●	●	84*	8.6/32.7
Medium				140°F		140°F
				(60°C)		(60°C)
	●			●	●	●	●	75*	6.9/26.2
Light						140°F
						(60°C)
		Use this cycle for pre-					Use
		rinsed and lightly-					covered
		soiled loads. This cycle					detergent
		uses less hot water					dispenser
		than the Normal Wash					section.
		cycle.
Soil	Pre-		Rinse	Main	Rinse	Final	Dry	Time	Water
Level	Wash			Wash		Heated		(min)	Usage
Sensed						Rinse			(gal/L)
			●	●	●	●	●	78*	8.6/32.7
Heavy				140°F		140°F
				(60°C)		(60°C)
				●	●	●	●	68*	6.5/24.5
Light						140°F
						(60°C)
		Use this cycle for china					Use
		and crystal. This cycle					covered
		uses a light wash and					detergent
		gentle dry. During the					dispenser
		heated dry, the heating					section.
		element cycles on and
		off.
Soil	Pre-		Rinse	Main	Rinse	Final	Dry	Time	Water
Level	Wash			Wash		Heated		(min)	Usage
Sensed						Rinse			(gal/L)
			●	●	●	●	●	74*	8.6/32.7
Heavy						130°F	cycled
						(54°C)
				●	●	●	●	64*	6.5/24.5
Light						130°F	cycled
						(54°C)

14

	Use this rinse cycle for			Do not
	rinsing dishes, glasses,			use
	and silverware that will			detergent
	not be washed right			with this
	away.			cycle.
Soil	Pre- Rinse	Main Rinse	Final	Dry Time	Water
Level	Wash	Wash	Heated	(min)	Usage
Sensed			Rinse		(gal/L)
	●	●		14	4.3/16.4
Heavy
		●		10	2.2/8.2
Light

†A small amount of water is run through the pump to remove soil particles between the main wash and final rinse.

NOTE: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary from the numbers above as the sensor adjusts the cycle for the best wash performance.

Canceling a Cycle

Anytime during a cycle, press

CANCEL glows. The dishwasher pauses for 5 seconds and starts a 2 minute drain (if needed). Let the dishwasher drain completely. The light goes off when the dishwasher finishes the drain.

To stop the drain

You can press Cancel again to stop the drain immediately. Remember to drain the dishwasher before starting a new cycle.

NOTE: A small amount of water remains in the dishwasher. This is normal.

To clear the indicators

Press Cancel before starting the dishwasher to clear all options and cycles.