KitchenAid W10321621D Install Moisture Barrier Under a wood countertop, Prepare Dishwasher

Page 11

Option D, No waste disposer – with air gap

1.Connect rubber end of drain hose to

air gap and cut if needed. NOTE: Do not cut ribbed section.

2.Attach drain hose to air gap with

large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 1¹⁄₂" to 2" (3.8 to 5 cm) screw-type clamp (not provided).

3.Use a rubber hose (not provided)

with screw-type clamps (not provided) to connect from waste tee to air gap.

Install Moisture Barrier

(under a wood countertop)

1.Make sure the area under the cabinet is clean and dry for installation of the moisture barrier.

2.Remove the backing of the moisture barrier and apply to underside of the countertop along the front edge of the counter.

Prepare Dishwasher

WARNING

Tip Over Hazard

Do not use dishwasher until completely installed. Do not push down on open door.

Doing so can result in serious injury or cuts.

WARNING

Excessive Weight Hazard

Use two or more people to move and install dishwasher.

Failure to do so can result in back or other injury.

Helpful Tip: Place cardboard under dishwasher until installed in cabinet opening to avoid damaging floor covering. Do not use door panel as a worktable without first covering with a towel to avoid scratching the door panel.

Using 2 or more people, grasp sides of dishwasher door frame and place dishwasher on its back.

11

Image 11
Contents Installation Instructions Undercounter Dishwasher Table of Contents Supplied in Kit All InstallationsAddition, for first-time installations Tools and PartsCall 1-800-422-1230 to order Location RequirementsPage Water Supply Requirements If connecting dishwasher with a power supply cordIf connecting dishwasher with direct wiring Drain RequirementsPrepare Cabinet Opening-New Utilities Prepare Cabinet Opening-Existing Utilities Prepare and Route Water Line Option B, Direct WireInstall Drain Hose Option C, Waste disposer with air gap Option A, Waste disposer no air gapOption B, No waste disposer no air gap Option D, No waste disposer with air gap Install Moisture Barrier Under a wood countertopPrepare Dishwasher Option B, Remove Access Panel Metal Panel Make Power Supply Cord ConnectionOption A, Remove Access Panel Plastic Panel Page Determine Cabinet Opening Follow steps below Install Door HandleCustom Panel Dimensions Install Custom Panel Page Option A, Countertop attachment Choose Attachment OptionOption B, Dishwasher side attachment Prepare Water Supply LineMove Dishwasher Close to Cabinet Opening Page Page Connect to Drain Connect to Water SupplyMake Direct Wire Electrical Connection Secure Dishwasher in Cabinet Opening Option A, Install Access Panel Plastic Panel Complete InstallationOption B, Install Access Panel Metal Panel Additional Tips Reconnect PowerCheck Operation If Dishwasher Does Not OperateIl faut Table DES MatièresFourniture dans la trousse Toutes les installations’autre part, pour les premières installations Outillage et piècesExigences demplacement Page Pour le raccordement direct du lave-vaisselle Exigences d’évacuationSpécifications de l’alimentation en eau Spécifications électriquesInstructions Dinstallation Option B, raccordement direct Préparation et acheminement de l’alimentation électriqueOption A, cordon d’alimentation Préparation et acheminement de la canalisation d’eau Option B pas de broyeur à déchets sans brise-siphon Installation du tuyau d’évacuationOption a broyeur à déchets sans brise-siphon Option D pas de broyeur à déchets avec brise-siphon Option C broyeur à déchets avec brise-siphonOption B Retrait du panneau daccès Panneau métallique Préparation du lave-vaisselleOption a Retrait du panneau daccès Panneau en plastique Raccordement du cordon dalimentation Avertissement Évaluation de l’ouverture dencastrement du placard Exécuter les étapes ci-dessous Installation de la poignée de portePage Page Option B, Fixation au côté du lave-vaisselle Choix de l’option de fixationOption A, Fixation au plan de travail Préparation de la canalisation Dalimentation en eau Remarques Raccordement à l’alimentation en eau Raccordement électrique direct Raccordement au circuit dévacuationAvertissement Remarques Option a Installation du panneau daccès Panneau en plastique Achever linstallationOption B Installation du panneau daccès Panneau métallique Rétablir la source de courant électrique Contrôle du fonctionnementSi le lave-vaisselle ne fonctionne pas Conseils supplémentairesPage Page W10321621D