KitchenAid W10321621D installation instructions

Using the template provided, attach it to the backside of the custom panel with tape. Make sure that the center of the template is aligned with the center of the wooden panel and top of the template is aligned to the top face of the wooden panel.

NOTE: Do not drill deeper then ⁵⁄₈" (16 mm) to keep from drilling through panel. Pilot hole depths given are for ³⁄₄" (19 mm) thick panel.

Mark 4 pilot holes on the wooden panel using the template provided. Predrill 4 pilot holes using a ³⁄₃₂" drill bit. Use tape to mark the drill bit to gauge hole depth. Drill pilot holes approximately ⁵⁄₈" (16 mm) into the custom panel.

Attach the 4 plastic studs to the wooden panel using the 4 short hex-head (⁵⁄₁₆") screws provided.

Check custom tape alignment with metal door slots; verify tape is right-side up, and that the tape does not overhang the metal door on the top, bottom or side interfaces. Remove the backing from the custom tape by pulling straight down on the liner. Align the custom tape to the keyhole slots on the metal door (see image) and apply. Repeat steps for one side and then the other.

NOTE: The adhesive on the tape is aggressive, so proper alignment and attachment to the metal door needs to occur on the first try.

Align the studs on the custom wood panel to the keyhole slots on the door assembly. Ensure that all 4 plastic studs are engaged in the keyhole slots. Slide wood panel down until the top surface of the wooden panel is flush with the top of the door.

16