KitchenAid KUDD03DT Option 2 Install custom front panels, Custom front panel dimensions

Option 2: Install custom front panels

Custom front panel dimensions

		2-5/16"
		(5.9 cm)
	9"
	(22.9 cm)
medallion			15-		5/8"
cutout area				(39.7 cm)
Top panel		5"
		(12.7 cm)
(front view)

23-7/16" (59.5 cm)

		2-1/8"
	9"	(5.4 cm)
	(22.9 cm)
medallion			14"
cutout area				(35.6 cm)
Bottom panel		5"
(front view)		(12.7 cm)

23-7/16" (59.5 cm)

1.Prepare the custom front panels to specifications shown.

2.Mount the handle to the custom panel. The screws must not extend beyond the back surface of the panel. (Handle is customer supplied, location is customer preference.)

3.Lay the custom front panel face down on a protective covering.

4.Measure and mark the vertical centerline and horizontal position line on the back of the front panels.

	mark
Top Panel -	horizontal line
1-7/16" (36.5 mm)
Bottom panel -	mark
1-3/16" (30.2 mm)	centerline

5.Feed the wires of the medallion connector through the front of the custom front panel and push the medallion into the prepared medallion hole.

6.Remove the pins on both sides of the dishwasher drawer by pulling the pins straight out with a pair of needle- nose pliers.

pin

	1-9/32"
1-7/32"	(32.6 mm)
(30.8 mm)	max.

end may be round or squared off

1/4"

(6.4 mm)

7.Gently pull the bottom of the metal plate away from the dishwasher, and then pull down.

1-13/64"

NOTE: Do not cut beyond outline of medallion cutout.

Rout a 1/4" (6.4 mm) radius around back side of medallion cutout.

2-13/32" (60.8 mm)

(30.6 mm)

Medallion cutout

(front of panel)

Upper and lower panel minimum thickness is 5/8" (16 mm). Panel thickness above 11/16" (18 mm) can be accommodated but product depth will increase accordingly.

Custom front panel material must be suitable for damp conditions or adequately sealed to withstand moisture. Using a moisture-resistant material can provide additional protection. Taping edges alone may not provide adequate sealing. For painted panel, paint all rear edges to improve sealing.

8.Lay the custom front panel face down.

9.Feed the medallion wires through the wire opening in the metal plate.

metal plate

wire opening

front panel

13