KitchenAid KUDD03DT Installation Requirements, Tools and Parts, Location Requirements

Page 3

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Location Requirements

IMPORTANT: Observe all governing codes and ordinances. Failure to meet codes and ordinances could lead to fire or electrical shock.

Proper installation is your responsibility:

Tools needed:

■utility knife

■needle-nose pliers

■tape measure

■flat-bladed screwdriver

■#2 Phillips screwdriver

■side cutting pliers

■pencil

■sandpaper

■level

■wood cutting board

■adjustable wrench that opens to 1-1/8" (29 mm)

Parts supplied:

■7 mm socket wrench

■5 mm socket wrench

■5 mm open end or box end wrench

■electric or hand drill

■1-1/2" hole saw

■valve (sized to fit hot water supply line) with 3/8" male compression fitting

■protective floor covering

■Contact a qualified installer to ensure that the dishwasher is installed to meet all electrical and plumbing national and local codes and ordinances.

■Install the dishwasher as specified in these instructions.

■Have everything you need to properly install dishwasher.

■Protect dishwasher and water lines leading to dishwasher against freezing. Damage from freezing is not covered by the warranty.

■This dishwasher is manufactured for indoor use only.

■Install and level dishwasher on a floor that will hold the weight, and in an area suitable for its size and use.

Product dimensions

Located in bottom drawer:

■2 flexible trim pieces (for sides)

■1 flexible trim piece (for top)

■edge protection

■hose clamp, hose type

■washer

■2 installation brackets (top)

■drain hose support

■drain hose connector

■2 hose clamps, wire type

■24 #8 Phillips head wood screws

■toe panel

■custom toe panel mounting bracket

■moisture protection tape

22-7/16" *

23-7/16"

(57 cm)

(59.5 cm)

raised tabs for

optional top

attaching brackets

32-3/16" -

30" ***

34-1/2"

(76.2 cm)

(81.8 cm -

 

 

87.8 cm)

side

attaching

tabs

2"– 4-3/8" **

20-15/32"(5 cm – 11 cm)

(52 cm) drawer open

*If custom wood panels are to be used, the product depth is specified with an 11/16" (18 mm) door panel thickness.

**Toe panel depth: Factory supplied, 2– 4-3/8" (5 – 11 cm); Custom wood, 5" (12.7 cm) less the toe panel thickness for integrated. Minimum panel thickness using the supplied screws is 3/8" (9 mm).

***Door front height: Factory supplied – 30" (76.2 cm); Custom wood – 28-1/4" (71.8 cm) minimum.

NOTE: Product shown with front panels for dimension purposes.

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Installation Instructions Drawer Dishwasher Table of Contents Drawer Dishwasher SafetyLocation Requirements Installation RequirementsProduct dimensions Tools and PartsFor a grounded, cord-connected dishwasher Cabinet dimensions/requirementsWater Supply Requirements Electrical RequirementsElectrical Connection Installation InstructionsOption 1 Power Supply Cord Method Prepare Cabinet OpeningRemove factory-installed power cord Option 2 Direct Wiring MethodRemove the house wiring knockout Install Dishwasher If Installing Flexible Trim PiecesOption 1 Side attachment Choose attachment optionOption 2 Garbage disposal connection Install the Drain HoseOption 2 Top attachment Option 1 Sink drain waste tee connectionInstall Drawer Front Panels and Toe Panel Option 1 Install standard front panelsConnect to Water Supply Option 1 Install standard toe panel Custom front panel dimensions Option 2 Install custom front panelsCustom toe panel dimensions Option 2 Install custom toe panelIf dishwasher does not operate, check the following Complete InstallationPage Instructions d’installation Lave-vaisselle tiroir Table des matières Sécurité DU LAVE-VAISSELLE TiroirExigences Dinstallation Emplacement d’installationOutillage et pièces Pour un lave-vaisselle branché en permanence Dimensions/exigences du placardSpécifications de l’alimentation en eau Spécifications électriquesRaccordement électrique Instructions DinstallationPréparation de la cavité d’installation Méthode recommandée de liaison à la terreOption 2 Méthode par câblage direct Enlever le cordon d’alimentation installé à l’usineAvertissement Installation du lave-vaisselle Cas de linstallation de moulures Extrudées flexiblesOption 1 Fixation latérale Options de fixationOption 2 Connexion sur le broyeur à déchets Option 2 Fixation supérieureOption 3 Raccordement au brise-siphon Option 1 Installation des panneaux avant standardOption 1 Installation de la planche de plinthe standard Dimensions des panneaux avant personnalisés Option 2 Installation de panneaux avant personnalisésDimensions de la planche de plinthe personnalisée Option 2 Installation une de plinthe personnaliséeAchever l’installation

KUDD03DT specifications

The KitchenAid KUDD03DT is a versatile and stylish dishwasher that stands out for its exceptional performance and innovative design. This model is engineered with a range of features and technologies that enhance efficiency and cleaning power, making it a popular choice for homeowners looking to upgrade their kitchen appliances.

One of the standout features of the KUDD03DT is its powerful cleaning system, which utilizes a multi-dimensional wash system to ensure that every dish, regardless of size or shape, comes out sparkling clean. The dishwasher is equipped with rotating wash arms that provide thorough coverage, directing water to every corner of the interior. This feature is especially beneficial for larger pots and pans, which often require more meticulous attention during the washing process.

Energy efficiency is another significant characteristic of the KitchenAid KUDD03DT. It is designed to consume less water and energy than traditional dishwashers, making it an environmentally friendly option. The unit is ENERGY STAR certified, providing reassurance that it meets stringent energy efficiency standards. Homeowners can save on utility bills while also contributing to a sustainable lifestyle.

The KUDD03DT also boasts a spacious interior, with adjustable racks and multiple loading options. This flexibility allows users to customize the interior space to fit their specific needs, accommodating everything from delicate glassware to heavy cookware. The upper rack features a dedicated stemware holder, which securely supports wine glasses and prevents them from tipping over during the wash cycle.

In terms of technology, the KUDD03DT includes a soil sensor that detects the level of dirtiness of the dishes and adjusts the wash cycle accordingly. This smart technology ensures optimal cleaning while conserving water and energy. Additionally, the dishwasher features a quiet operation, with sound-dampening materials that minimize noise, helping to maintain a peaceful home environment even during wash cycles.

Overall, the KitchenAid KUDD03DT combines practicality and sophistication. With its robust cleaning capabilities, energy-efficient design, and thoughtful features, it is an excellent investment for any kitchen. Whether entertaining guests or managing everyday meals, this dishwasher excels in performance, reliability, and user-friendliness, making it a top choice for discerning homeowners.
Top Page Image Contents