IMPORTANT:
■Operate your dishwasher only when you are at home.
■If your home is equipped with a water softener, do not start the dishwasher during the regeneration of the softener.
Status Indicators
Follow the progress of your dishwasher with the Cycle Status indicators.
Wash System
The
■The wash water continuously flows through the Ultra- Fine filter, trapping food particles.
/ 
Add Rinse Aid
Fill the Rinse Aid dispenser when Add Rinse Aid is lit. A rinse aid prevents water from forming droplets that can dry as spots or streaks.
If the Rinse Aid dispenser is empty, the light glows when you select a cycle or while a cycle is running.
Sensing/Soak
Your dishwasher senses the soil level on the dishes. Soil level determines the length of some cycles, the amount of heat or water added, and the cycle needed for the load. Soaks help loosen soils on the dishes.
Sensing/Soak glows during the sensing and soak parts of the cycle. Wash action continues while sensing occurs. Wash action pauses during a soak.
Add a Dish
After a cycle starts, you can add an item to your dishwasher while Add A Dish glows. After the light turns off, items added to the dishwasher may not be completely cleaned.
Water Heating
Water Heating glows, and the cycle progression pauses, whenever water is heated to a set temperature during a cycle.
Wash or rinse action continues as the water heats.
Clean
Clean glows when a cycle is finished. The light turns off when you open and close the door or press Cancel/Drain.
Sanitized
If you select the Sani Rinse option, Sanitized glows when the Sani Rinse cycle is finished. If your dishwasher did not properly sanitize your dishes, the light flashes at the end of the cycle. This can happen if the cycle is interrupted or the incoming water temperature is too low. The light goes off when you open and close the door.
■As the
■Two water jets, located under the spray arm remove the food particles from the
■A coarse strainer prevents bones, pits, and other large objects from entering the pump system.
NOTE: Periodically check the coarse strainer and remove any objects on the strainer.
How the sensor adjusts the cycle:
While the dishwasher is “sensing,” it may perform a series of short drains and fills skimming off small amounts of soils and dirty water. These are simultaneously replaced with clean water. This removes trapped food particles from the pump for improved wash performance. Once soil level is determined, the sensor automatically adds heat, time, or water as needed for proper cleaning.
Drying System
During drying, you can see steam escaping through the vent at the upper left corner of the door. This is normal as the heat dries your dishes.
IMPORTANT: The vapor is hot. Do not touch the vent during drying.
Overfill Protection Float
The overfill protection float (in the front right corner of the dishwasher tub) keeps the dishwasher from overfilling. It must be in place for the dishwasher to operate.
Check under the float for objects that may keep the protector from moving up or down.
15