KitchenAid 8573157 Connect to drain, Secure dishwasher in cabinet opening

Connect to drain

1.To help minimize

vibration, route drain	drain
hose to avoid contact
with motor, door springs,	loop
water line, cabinet,
flooring or the edge of
the hole where it passes
through the cabinet.

2. Do not remove drain

loop from side of dishwasher.

3.Place pan under end of drain hose. Pan will collect any water in drain hose.

4.Place the smaller drain hose clamp onto the small end of the drain hose.

hose clamp

5.Push the drain hose into the connector up to the stop on the drain hose.

connectorstop

6.Use pliers to open clamp and slide clamp onto connector between stops on connector as shown.

hose clamp

stops

Secure dishwasher in cabinet opening

WARNING

Tip Over Hazard

Do not use dishwasher until completely installed. Do not push down on open door.

Doing so can result in serious injury or cuts.

1.If you have not already done so, open dishwasher door and place towel over pump assembly and spray arm of dishwasher. This will prevent screws from falling into pump area when securing dishwasher to countertop.

2.Check that dishwasher is still level and centered side to side in the opening.

3.Secure dishwasher to countertop or sides of cabinet with two, #10 x 1/2" Phillips-head screws. The dishwasher must be secured to keep it from tipping when door is opened. Do not drop screws into bottom of dishwasher.

	screw to
OR	side cabinet

screw to countertop

4.Open door about 3 inches (7.6 cm) and check that space between inner door and tub is equal on both sides. If spacing is not equal, loosen bracket screws and shift tub. Tighten bracket screws.

5.Check that top of door does not contact screws, brackets, or countertop. If it does, dishwasher must be lowered and re-leveled.

6.If securing to sides of cabinet, replace the plastic buttons.

plastic button

7.Remove towel from dishwasher.

8.Reinstall the lower dishrack.

15