KitchenAid 8573157 installation instructions Installation Instructions, Install the drain hose

Page 6

Installation Instructions

WARNING

Electrical Shock Hazard

Disconnect electrical power at the fuse box or circuit breaker box before installing dishwasher.

Failure to do so can result in death or electrical shock.

1.Disconnect power.

2.Turn off water supply.

Prepare cabinet opening using existing utility hookups

Follow the steps in this section if you are installing the dishwasher in an existing cabinet opening with utility hookups.

If you are installing the dishwasher in a cabinet opening that does not have hookups, follow the steps under "Prepare cabinet opening where there are no existing utility hookups" section.

Install the drain hose

IMPORTANT: Always use a new drain hose even when installing a new replacement dishwasher.

1.Drill a 1-1/2" (3.8 cm) diameter hole in cabinet wall or floor on the side of the opening closest to the sink.

2.Connect drain hose to waste tee or waste disposer using one of the following methods:

Option 1, Waste disposer – with air gap

Option 2, No waste disposer – with air gap

Option 3, Waste disposer – no air gap*

Option 4, No waste disposer – no air gap*

*an air gap is recommended

Helpful Tip: To reduce the vibration of the hose, keep the hose away from the floor and the edge of the hole where it passes through the cabinet.

Option 1: Waste disposer – with air gap:

1. Remove the disposer knockout plug. Cut end of drain

hose if needed (do not cut ribbed section).

2. Attach drain hose to air gap with large spring-type

clamp. If the drain hose was cut, use a 1-1/2" to 2"

(3.8 to 5 cm) screw-type clamp*.

1.Check that the water line reaches to the front left of opening where the water connection will be made.

2.Check that the direct wire reaches to the front right of opening where the electrical connection will be made.

water line

direct wire

6" (15.2 cm)

3. Use a rubber hose connector* with spring or screw-

type clamps* to connect air gap to disposer inlet.

This connection must be before the drain trap and at

least 20" (50.8 cm) above the floor where dishwasher

will be installed.

drain hose –

 

cut here if needed

 

rubber hose

 

connector

air gap

 

spring or

 

If the water line and the direct wire reach far enough into the opening, proceed to the next section “Install the drain hose.“ If they do not reach far enough, follow the steps under “Prepare cabinet opening where there are no existing utility hookups.”

screw-type

 

large

clamps

 

 

spring-type

 

 

 

 

clamp

 

disposer

drain

 

hose

 

inlet

 

 

drain trap

 

 

4. Insert drain hose

drain hose

 

through hole cut in

 

 

cabinet to the front

 

 

center of opening where

 

 

drain connection will be

 

 

made.

 

 

* Parts available from local plumbing supply stores

6

Image 6
Contents Installation Instructions Undercounter Dishwasher Dishwasher Safety Table of ContentsYou need to Addition, for new installations Installation RequirementsAll installations Tools and PartsProduct dimensions Cutout dimensionsDrain Requirements If direct wiring dishwasherIf connecting dishwasher with a power supply cord Water Supply RequirementsInstall the drain hose Installation InstructionsPrepare cabinet opening using existing utility hookups Option 1 Waste disposer with air gapOption 2 No waste disposer with air gap Option1 Direct wire methodElectrical connection Option 4 No waste disposer no air gapInstall the water line Option 2 Power supply cord methodPrepare dishwasher If you have built-up floors Install the door handle on some models Install door panelOption 1 Countertop attachment Choose attachment optionCheck door spring tension Option 2 Dishwasher side attachmentMove dishwasher into cabinet opening Option 1 Direct wire methodMake Electrical Connection Level the dishwasherConnect to water supply Connect to drain Secure dishwasher in cabinet openingBottom sound pad installation on some models Complete installationCheck operation If dishwasher does not operatePage Sécurité du lave-vaisselle Table des matièresTenir compte de ceci Pour toutes les configurations d’installation Exigences d’installationEmplacement d’installation Outillage et piècesDimensions du produit Dimensions de l’espace d’installationSpécifications électriques Spécifications de la canalisation d’évacuationSpécifications de l’alimentation en eau Pour le raccordement direct du lave-vaisselleInstructions d’installation Installation du tuyau d’évacuationOption 1 broyeur à déchets avec brise-siphon Option 4 pas de broyeur à déchets sans brise-siphon Raccordement électriqueOption 2 pas de broyeur à déchets avec brise-siphon Option 3 broyeur à déchets sans brise-siphonInstallation de la canalisation d’eau Option 2 raccordement par cordon d’alimentationPréparation du lave-vaisselle Plancher rehaussé Installation de la poignée de porte Installation du panneau de la porteOption Choix de la méthode d’immobilisation de l’appareil Contrôle de la tension des ressorts de la porteOption Fixation sur le plan de travail Établissement de l’aplomb du lave-vaisselle Insertion du lave-vaisselle dans l’espace d’installationRaccordement électrique Option 1 Câblage directRaccordement à la canalisation d’eau Raccordement à la canalisation d’évacuation Installation du panneau d’insonorisation Dernières opérations de l’installationAlimentation de l’appareil par câblage direct Contrôle du fonctionnement Si le lave-vaisselle ne fonctionne pas correctementPage Imprimé aux É.-U

8573157 specifications

The KitchenAid 8573157 is a versatile and highly regarded appliance designed to elevate your culinary experience. This model is part of KitchenAid's robust lineup of kitchen tools, specifically engineered to tackle a variety of cooking tasks with ease and efficiency.

One of the standout features of the KitchenAid 8573157 is its impressive 5-quart mixing bowl, crafted from stainless steel for enhanced durability. This generous capacity allows users to prepare large batches of dough, batter, or other mixtures, making it ideal for families or entertaining guests. The bowl also includes a convenient handle that ensures a secure grip while pouring or mixing.

The KitchenAid 8573157 is powered by a 300-watt motor, providing consistent and powerful performance. This motor enables the appliance to handle even the toughest mixing tasks, from kneading dense bread dough to whipping cream. With multiple speed settings, users can easily adjust the mixer's intensity according to their specific needs, ensuring optimal results every time.

Another notable aspect of this mixer is its planetary mixing action. This innovative technology allows the mixing attachment to move in a different direction than the bowl, ensuring thorough ingredient incorporation. As a result, users can achieve perfectly mixed ingredients without the need to stop and scrape down the sides of the bowl.

The KitchenAid 8573157 is also compatible with a wide range of attachments, making it a multifunctional kitchen tool. From pasta makers to food grinders, these attachments expand the appliance's capabilities, allowing users to explore various culinary techniques. This flexibility is particularly appealing to home chefs who appreciate the convenience of using one base machine for multiple functions.

In terms of design, the KitchenAid 8573157 showcases a classic aesthetic that fits seamlessly into any kitchen decor. Available in various colors, it allows users to choose a model that matches their personal style. Additionally, the sturdy construction ensures that this mixer is built to last, with many users reporting years of reliable performance.

Overall, the KitchenAid 8573157 stands out due to its robust features, advanced technologies, and user-friendly design, making it an essential tool for both novice cooks and experienced chefs. It not only simplifies the cooking process but also inspires culinary creativity, providing an enjoyable cooking experience for anyone who uses it.