Krups XP 1500 manual Pause and Serve Feature, Cleaning the coffeemaker, Decalcifying Coffeemaker

2.Place the glass carafe with lid in position on the warming plate.

3.Turn « ON » your appliance in drip coffee mode using the selector knob (S). The indicator light will illuminate indicating that the brewing process has begun (9).

4.As long as the blue indicator light is illuminated the coffee will be kept warm.

Pause and Serve Feature

The Pause and Serve feature automatically stops the flow of brewed coffee through the filter cone if the glass carafe is removed from the warming plate during the brewing cycle. You have about 20 seconds between the removal of the carafe and it being reinserted back onto the warming plate.

The Pause and Serve device closes off the filter cone so effectively that there is virtually no coffee dripping onto the warming plate. Once the carafe is replaced, the brewing process and the flow of coffee into the carafe will resume.

CAUTION

If significant amounts of coffee drip onto the warming plate afer the carafe has been removed, please check the seal in the filter holder to ensure it is placed properly. If a requirement seal is needed, please contact one of our main service centers or our main parts center.

If the filter is overfilled with coffee grounds, it could cause the water that jets into the filter cone to overflow between the filter and the sides of the filter cone. Be sure to use the proper amount of ground coffee.

If this blockage and subsequent dripping does occur, put the glass carafe immediately back onto the warming plate, and allow the full brewing cycle to run its course. Do not swing out the swivel filter until the brewing process is completed.

Cleaning the coffeemaker

Always unplug this appliance before cleaning. Clean the filter basket, carafe, and lid in a solution of warm water and mild liquid soap. These parts can also be placed in

12

the upper level of your dishwasher away from the heating and drying element for safe effective cleaning.

Never use scouring agents.

Never immerse the appliance itself in water. To clean, simply wipe off with a soft, damp cloth.

Never use a cloth to clean inside of the water chamber, as this might leave residual deposits in the chamber. Just rinse with cold water periodically.

Decalcifying the

coffeemaker

The warranty does not cover faulty or

broken machines that are not properly

descaled.

The coffeemaker must be decalcified regularly. The frequency depends on the hardness of your water and how often you use the coffeemaker.

Recognizable indications that descaling is necessary are :

-increase noise during boiling,

-longer preparation time.

If usage is frequent, descaling should be carried out as follows :

-with soft water once a year,

-with medium hard water every quarter year,

-with hard water once a month.

In doubt regarding the water hardness in your area, you may call your local water department.

As descaling agent we recommend the use of reference solution N°F054 from Satisfusion 1 Service at 888-344-0727.

Dissolve a packet of Krups descaling solution in 1/2 quart water and pour into the water container. Run this through 2 or 3 times as if making coffee, but using no ground coffee. The hot descaling solution must be allowed to cool down before being poured into the water container. Finally do the same twice using clear water.

XP1500/1530 US/F/E.PM6.5 12

16/03/05, 10:52