Hotpoint LTF 11S112 manual Start-up and use, Starting the dishwasher, Measuring out the detergent

Page 11

Start-up and use

Starting the dishwasher

1.Turn the water tap on.

2.Open the door and press ON-OFF button.

3.Measure out the detergent. (see adjacent information).

4.Load the racks (see Loading the racks).

5.Select the wash cycle in accordance with the type of crockery and its soil level (see table of wash cycles) by pressing the P button.

6.Select the wash options*. (see Special wash cycles and options).

7.Start the wash cycle by shutting the door.

8.The end of the wash cycle is indicated by beeps and by the flashing of the wash cycle number on the display. Open the door, switch off the appliance by pressing the ON/OFF button, shut off the water tap and unplug the appliance from the electricity socket.

9.Wait for a few minutes before removing the crockery, in order to avoid burns. Unload the racks, beginning with the lower level.

- The machine will switch off automatically during certain extended periods of inactivity, in order to minimise electricity consumption.

AUTO WASH CYCLES*:some models of dishwashers are equipped with a special sensor which can be used to assess the level of soiling and automatically setting the most efficient and economic wash cycle accordingly.

The duration of the Auto wash cycles may vary due to the operation of the sensor.

If the crockery is only lightly soiled or if it has been rinsed with water before being placed in the dishwasher, reduce the amount of detergent used accordingly.

Modifying a wash cycle in progress

If a mistake was made during the wash cycle selection process, it is possible to change the cycle, provided that it has only just begun: open the door taking care to avoid the escaping steam, by pressing and holding the ON/OFF button, the machine will switch off. Switch the machine back on using the ON/OFF button and select the new wash cycle and any options desired; start the cycle by closing the door.

Adding extra crockery

Without switching off the machine, open the door, taking care to avoid the escaping steam, and place the crockery inside the dishwasher. Shut the door and the cycle will begin from the point at which it was interrupted.

Accidental interruptions

If the door is opened during the wash cycle, or if there is a power cut, the cycle stops. It starts again from the point at which it was interrupted once the door has been shut or the electricity supply is restored.

*Only available in selected models.

Measuring out the detergent

GB

A good wash result also depends on the correct

 

amount of detergent being used. Exceeding the stated

 

amount does not result in a more effective wash and

 

increases environmental pollution.

 

Based on how soiled the items are, the amount can be adjusted to individual cases using powder or liquid detergent.

In the case of normally soiled items, use approximately either 35 gr (powder detergent) or 35 ml (liquid detergent). If tablets are used, one tablet will be enough.

If the crockery is only lightly soiled or if it has been rinsed with water before being placed in the dishwasher, reduce the amount of detergent used accordingly.

For good washing results also follow the instructions shown on the detergent box.

For further questions please ask the detergent producers' Advice Offices.

To open the detergent dispenser use the opening device “A”.

Introduce the detergent into the dry dispenser “B” only. Place the amount of detergent for pre-washing directly inside the tub.

1.When measuring out the detergent refer to the Table of wash cycles to add the proper quantity. Compartment B comprises a level showing the maximum quantity of liquid or powder detergent that can be added to each cycle.

2.Remove detergent residues from the edges of the dispenser and close the cover until it clicks.

3.Close the lid of the detergent dispenser by pulling it up until the closing device is secured in place.

The detergent dispenser automatically opens up at the right time according to the wash cycle.

If all-in-one detergents are used, we recommend using the TABS option, because it adjusts the cycle so that the best washing and drying results are always achieved.

Only use detergent which has been specifically designed for dishwashers.

DO NOT USE washing-up liquid.

Using excessive detergent may result in foam residue remaining in the machine after the cycle has ended.

The use of tablets is only recommended for models which offer the MULTI-FUNCTIONAL TABLETS option.

To achieve the best results from each washing and drying cycle, powder detergent, liquid rinse aid and salt should be used.

11

Image 11
Contents LTF 11S112 Instructions for useHotpoint Product FicheSaving energy and respecting the environment Precautions and safety adviceGeneral safety Disposal of old electrical appliancesRecycling & Disposal Information Electrical Connection InstallationPositioning and levelling Anti-condensation strip Connecting the water suppliesConnecting the water inlet hose Sink Waste SystemAnti-flooding protection Advice regarding the first wash cycleControl panel Description of the applianceLower rack Tip-up compartments with adjustable positionLoading the racks Upper rackDamage to glass and crockery Adjusting the height of the upper rackThird rack Unsuitable crockeryMeasuring out the detergent Start-up and useStarting the dishwasher Wash cycle Wash cyclesWash options Special wash cycles and OptionsMeasuring out the rinse aid Adjusting the amount of rinse aidSetting the water hardness Rinse aid and refined saltCare and maintenance Problem Possible causes / Solutions TroubleshootingEssential Contact Information After Sales ServiceAfter Sales Service Parts and AccessoriesExtended Guarantees GuaranteeMonths Parts and Labour Guarantee Year Parts GuaranteePage 195110470.04