DeLonghi DEFSGG 36 warranty ANTI-TIP Stability Device Installation Instructions, 28 15/16 735 mm

Page 12

YOU MUST USE STABILITY ANTI TIP BRACKET TO PREVENT UNIT FROM TIPPING.

ANTI-TIP STABILITY DEVICE INSTALLATION INSTRUCTIONS

1.The anti-tip bracket has to be attached as shown on figure below, it has to be fixed on the rear wall by no. 2 (two) suitable screws (supplied with the anti-tip kit).

2.After fixing the anti-tip bracket, slide range into place. Be sure the anti-tip bracket is fully inserted in the slot of the range back.

6"	15/64

(158.5 mm)

28" 15/16 (735 mm)

top of cooktop	range installed	final position
from	with	in

Dotted line showing the position of the range when installed

ANTI-TIP STABILITY

DEVICE FIXING

Anti-tip stability device

Slot for inserting the anti-tip bracket

Fig. 1.10

12

Image 12

Contents Double Oven GAS Range ALL Ranges can TIP Data Plate Conversion Label Installation Instructions Tools Needed for InstallationReplacement Parts Electrical Grounding InstructionsInstallation Proximity to Side CabinetsGAS and Electric Connection 500 305 Fitting the Adjustable Feet Levelling the CookerMoving the Cooker It is mandatory to install Assembling the BackguardOr the Island Trim Backguard or the island trimANTI-TIP Stability Device Installation Instructions 28 15/16 735 mmManual Shut-off Valve fig Explosion HazardPressure Regulator Pressure Regulator Installation Step Step Step Pressure Regulator Installation Range Manifold Manifold male Pipe fittingLeak Testing Flexible ConnectionsRigid Pipe Connections Setting the Pressure Regulator fig Conversion to LP/PROPANE GASInjectors Table BurnersSetting the Burner Minimum Semirapid and triple ring burnersOven Burner Adjustment of the Oven Burner Minimum Left and Right Oven Electrical connection Recommended ground methodWiring Diagram TL2 TL3 TL4 TL1 PA1Page Page Cod ß6