DeLonghi DEFSGG 36 warranty Pressure Regulator Installation Step

Page 14

PRESSURE REGULATOR INSTALLATION

STEP 1

Mount the 1/2” NPT (conical) male connector to the pressure regulator and tighten by using a wrench.

Do not over tighten the connector. Over tightening may crack regulator.

LOCK

Arrow

Fig. 2.2a

14

STEP 2

Assemble the 1/2” NPT connector + pressure regulator group to the extension pipe interposing the gasket supplied. The regulator cover must be ordiented toward the front side of the range.

IMPORTANT: use two spanners to tighten the connection.

Regulator cover

Fig. 2.2b

Image 14

Contents Double Oven GAS Range ALL Ranges can TIP Data Plate Conversion Label Installation Instructions Tools Needed for InstallationReplacement Parts Electrical Grounding InstructionsInstallation Proximity to Side CabinetsGAS and Electric Connection 500 305 Moving the Cooker Fitting the Adjustable FeetLevelling the Cooker Or the Island Trim It is mandatory to installAssembling the Backguard Backguard or the island trimANTI-TIP Stability Device Installation Instructions 28 15/16 735 mmPressure Regulator Manual Shut-off Valve figExplosion Hazard Pressure Regulator Installation Step Step Step Pressure Regulator Installation Range Manifold Manifold male Pipe fittingRigid Pipe Connections Leak TestingFlexible Connections Setting the Pressure Regulator fig Conversion to LP/PROPANE GASInjectors Table BurnersSetting the Burner Minimum Semirapid and triple ring burnersOven Burner Adjustment of the Oven Burner Minimum Left and Right Oven Electrical connection Recommended ground methodWiring Diagram TL2 TL3 TL4 TL1 PA1Page Page Cod ß6