Subreflector
Assembly and
Adjustment
Step 1
Step 2
Install subreflector subassembly to subreflector ring by inserting studs on subassembly into adjustment stud mounting holes as shown in Figure 65.
•Use 3/4 in (19 mm) flatwasher, nut and jam nut
NOTE: 5” (127mm) dimension shown is a starting reference only. Dimension will vary after adjustments are complete.
Figure 65
Refer to Figure 66. Measure and note the distance between either outermost angle clip bolt head and the subreflector rim. Obtain the corresponding measurements from the remaining subreflector struts, and adjust the subreflector mounting hardware (4 places) to achieve a maximum differential of 1/16 inch.
Figure 66
50 | Installation Procedures |