Euro-Pro EP96W Citrus Juice Filter, Operating the Blender, Re-settable Thermal Safety Device

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS

Citrus Juice Filter

CAUTION: Make sure that the unit is unplugged from the power source and the speed control dial is in the “OFF” position before inserting or removing attachments.

WARNING: Always Operate The Juicer At Lowest Speed Only. Do Not Operate The Citrus Juicer At Higher Speeds.

1.Fit the processor bowl as detailed previously (page 4).

2.Fit the citrus juice filter into the processor bowl. (Fig. 26)

3.	Rotate counter	Fig. 26
	clockwise. Ensure
	that the citrus juice
	filter tab has clicked
	into place. (Fig. 27)
4.	Insert the juice	Fig. 27

reamer into the center of the citrus juice filter with its shaft inside the central column of the bowl. (Fig. 28)

Fig. 28

5.Plug in the appliance.

6.Place fruit on juice reamer and hold with a cupped hand.

7.Operate at minimum speed.

WARNING: Always operate the juicer at minimum speed only. Do not operate the citrus juicer at higher speeds.

Operating the Blender

Operating the Blender (Cont.)

2.Remove the safety cover. This can only be done once the processor lid has been removed.

	(Fig. 30)
3.	Place the blender	Fig. 30
	into its location on
	the processor body
	with the handle to the
	left. Turn counter
	clockwise until the
	blender clicks into
	place and the arrows	Fig. 31
	are aligned. (Fig. 31)
Warning: Use extreme caution -
blades are sharp. Handle carefully.
4. Place food in blender.
5. Place the blender lid
	and the measuring
	cap on the blender.
	(Fig. 32)
6.	Replace the
	processor bowl
	and processor lid.	Fig. 32
	Ensure that the lid
	tab has clicked into
	place. The blender
	will not operate if
	the processor lid is
	not clicked in place.
	Make sure that
	NO ATTACHMENTS	Fig. 33

are inside the food processor bowl when you are using the blender. (Fig. 33)

7.	Plug in the processor.
8.	Always operate the blender with the
	lid in place.
9.	Recommended speed levels for
	blending are between 5 - MAX.
	When blending soft vegetables or
	fruits start with level "5" and then go
	to a higher level. For hard

Operating the Blender (Cont.)

NOTE: You can crush 16 oz.

(500 ml) of ice cubes in the blender using the PULSE/TURBO button. CAUTION: To prevent spilling (overflow) do NOT operate the blender with more than 4 cups (1000 ml) of soft liquid (i.e. soup) at one time.

*Always operate the blender with the blender lid in place.

*When blending hot liquids, always remove the small measuring cap in the blender lid.

*Avoid contact with moving parts at all times.

*Keep hair, clothing as well as spatulas and other kitchen utensils out of the blender jar while in operation to reduce the risk of severe injury to persons or damage to the blender. A spatula may be used but ONLY when the unit is not in use.

NOTE:

TO REMOVE THE

BLENDER, YOU MUST

FIRST UNLOCK AND

REMOVE THE

PROCESSOR LID (A).Fig. 34

THEN UNLOCK AND REMOVE THE BLENDER (B) BY TWISTING CLOCKWISE. (Fig. 34)

WARNING:

ALWAYS REMOVE THE

BLENDER AND FIT THE

SAFETY COVER INTO THE Fig. 35

PROCESSOR BODY WHEN

USING THE PROCESSOR. (Fig. 35 & 36)

Re-settable Thermal Safety Device

Your Quad Blade Food Processor/Blender has been designed with a unique safety system which prevents damage to the unit’s motor and drive system, should you inadvertently overload your appliance. The safety system will automatically cut the electric power to the appliance when the device senses an overload or excessive temperature in the motor or drive system. Should this occur during use and the appliance stops functioning, following is the re-setting procedure:

1.Turn the “ON/OFF” speed control to the “OFF” position

2.Unplug the unit from the wall receptacle.

3.Remove and empty the processor bowl. Ensure that no food is jamming the cutting blades or attachments.

4.Allow the appliance to cool down for a minimum of 30 minutes.

5.Re-install the processor bowl and re-plug appliance in the wall outlet.

6.Proceed to use the appliance as before. Should the appliance still fail to operate, turn the “ON/OFF” speed control to the “OFF” position and unplug from the wall outlet. Allow the appliance to cool down for an additional 1 to 2 hours. After this time has passed, repeat the restart procedure, steps 5 and 6 above.

CAUTION: Make sure that the unit is unplugged from the power source and the speed control dial is in the “OFF” position before inserting or removing attachments.

1.Remove the processor bowl and lid. (Fig. 29)

Fig. 29

9

vegetables or fruit always use "

MAX" speed level.

IMPORTANT: Do NOT load the

blender with more than 10 oz.

(300 gr.) of hard vegetables at one

time. Do NOT operate continuously

for more than 20 seconds at one

time.

Fig. 36

10