Copy from UHC to

Loading Sequence Software should be loaded in this sequence:

• Main Board

• Language

• Row Display

• Distribution Boards

If the software update only involves a few of the components, following the loading sequence, skipping the unneeded component.

Incompatibility Message The cabinet can display an incompatibility message during software upgrades. The buttons will remain active. Follow the loading sequence and the incompatibility is corrected as the software components are loaded.

Cabinet Service Procedures

Update: Boards

1. Turn power off.

2. Insert flash drive in USB port located on cabinet bezel.

3. Turn power on.

4. Cabinet displays version numbers followed by current menu setting.

5. Press programming key.

6. Screen scrolls Enter Access Sequence.

7. Enter 98765 with keypad.

8. Press OK.

9. Scroll with arrow key until software section (see loading sequence box) to be updated is displayed on master control board.

10. Press OK.

11. Screen displays Copying Files, Please Wait. This takes several minutes.

12. Screen messages will vary, depending on software section being installed. Follow screen instructions.

13. Screen displays Complete.

14. Press OK.

15. Screen displays Main Boot Loading and a percentage of completion.

16.After 100% is displayed, screen goes blank and returns to menu display.

17.Turn cabinet off for 30 seconds and back on.

Update: Language File

1.With the unit on, press program button.

2.Enter 090709 with the keypad.

3.Press OK.

4.Screen displays Reconfigure OK or Cancel.

5.Press OK.

6.Screen displays Please Wait Lang Bin.

7.Screen displays 9 files copied.

8.Press OK.

9.Screen returns to normal display.

10.Turn cabinet off for 30 seconds and back on.

Capture Cabinet Menus/Configurations

The menu items and cabinet configurations in a cabinet can be captured and used to configure cabinets with identical software setups. Follow the instructions below to capture the menus and configuration from a cabinet.

1.Insert an empty flash drive in the USB socket on the cabinet with menus and configurations to be copied.

2.Press the programming key.

3.Enter 759248 with the keypad.

4.Press OK.

5.The master control will display

The configuration of a cabinet can be captured on an empty flash drive for transfer to cabinets with the same software setup.

2-2