Cleaning After Each USE, Cleaning Monthly, FLUSh

CLEANING - AFTER EACH USE

BEFORE CLEANING, MAkE SURE THE MACHINE IS SWITCHED OFF, UNPLUGGED AND ALLOWED TO COOL. Do not wash any of the plastic accessories in a dishwasher.

1 THE FILTERS

2 DRIP TRAY

3 THE NOzzLE

CLEANING - MONTHLY

BEFORE CLEANING, ENSURE THE MACHINE IS SWITCHED OFF, UNPLUGGED AND ALLOWED TO COOL. USE ESE PODS TO REDUCE FREqUENCY OF CLEANING.

1 WIPE BREWHEAD

2 UNSCREW

3 CLEAN BREWHEAD

Turn the filter holder (5) upside down over a bin and knock out the grounds. Be careful not to throw away the cup filter.

Empty the drip tray (15) regularly. If the red tray full indicator (7) is visable, empty immediately. Remove the non- slip mat and rinse after each use.

Pull the froth nozzle (14) off the wand (13) and wash under running water to remove any milk residue.

Wipe the entire brewhead

(4)area and ensure it is completely free of coffee grounds. Fine coffee grounds can block the showerhead.

Using a screwdriver and hammer, gently tap the screw to dislodge any dried coffee. Then unscrew anti-clockwise.

Thoroughly clean the showerhead and gasket to remove any coffee grounds. Use the filter pin (20) to unblock or rinse in suds.

4 WIPE THE WAND	5 fLUSh ThE	6 EMPTY WATER
	STEAM wAND

4 UNBLOCk FILTER

5 UNSCREW

6CLEAN THE STEAM WAND

After each use, clean the	IMPORTANT NOTICE:	Empty and rinse out after
wand with a damp cloth.	After each use, flush the	each session and refill with
There should be no milk	steam wand by dispensing	fresh water just before you
residue visible.	water or steam, this will	make your next round of
	remove any milk residue	espresso.
	from inside the steam wand.
	14

Filters often get blocked with prolonged use. To unblock, use the pin supplied (19) and push through the central hole on both sides of the filter to unblock.

Locate the measuring spoon

(18)onto the steam wand nut. Unscrew anti-clockwise and remove.

Use the steam pin (21) to remove dried milk from inside the steam wand. Use the measuring spoon to place the nut back on the steam wand. Screw clockwise until tight.