I Location ]
If you are installing your new refdgerator yourself, please follow these helpful su§ tions.
1. Remove base skids., [I J
Jii!: LJlJI
2.Remove all exterior and interior tape carefully and ._lli retain old tape. Make a small pad of this tape to pick
offany remainingtape residues. Thiswilleliminatethe '&_ need to use dangerous solvents of any kind.
3. Removeand discardthe cantilever shelf packingclips located just above each shelf where they hook onto
the frame. To remove the red plastic clip, wiggle it sideways and pull straight out.
4.Select a location for your new refrigerator away from any heat sources. Allow ; flow of air through the front base grille.
5.Your model should not be installed where the room temperature will go bel
55°F. because it will not run frequently enough to maintain proper temperat_ the freezer.
[Leveling Is Important I
To enhance its appearance, maintain efficient performance and for proper func the ice maker, your refrigerator should be level. Using a carpenter's level, ohec: refrigerator to make sure it is level front to back and side to side. The front wheel.' adjusted at the factory so the cabinet would be level. However, jarring in trar
standing the refrigerator onan uneven floormaycause the doors to shiftout of aligr ff leveling is necessary, remove the base grille and adjust the wheel with a scre_
as shown.
To lock the cabinet in place, turn down one or both |
| ||||
locking feet, located near the front wheels. Rear |
|
| |||
leveler feet are not required. |
|
|
|
| |
|
|
|
| TURNCOUNTER_t.OCk'_VI_E | |
! | TOCORRE_TTH,SCONDI* | [] |
|
| |
| TION, RAISE RIGHT | COR- | TO CORRECT | THIS CONOW[DN. | |
| NER AND/OR LOWER | LBFT | LEFT CORNER | AND/OR LOWER | |
| CORNER UNTIL DOORS | CORNERUNTILOOORSAUGN | |||
| ALIGN ACROSS TOP | OF | TO_ OF CABINET. | ||
| CABINET. |
|
|
|
|
|
|
| 4 |
|
|