Jenn-Air JXT9030BDP Safety Instructions, To Reduce the Risk of a Range TOP Grease Fire

Page 3

SAFETY INSTRUCTIONS

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

1.Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address listed in the warranty.

2.Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

3.Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards, including fire-rated codes and standards.

4.Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent backdrafting. Follow the heating equipment manufacturer’s guideline and safety standards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.

5.When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.

6.Do not use this range hood with any additional solid state speed control device.

7.Ducted fans must always be vented to the outdoors.

8.To reduce the risk of fire, use only steel ductwork.

9.This unit must be grounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

1.Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.

2.Always turn hood ON when cooking at high heat or when cooking flaming foods.

3.Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter.

4.Use proper pan size. Always use cookware appropriate for the size of the surface element.

WARNING

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:*

1.SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately,

EVACUATE AND CALL THE FIRE DEPARTMENT.

2.NEVER PICK UP A FLAMING PAN - You may be burned.

3.DO NOT USE WATER, including wet dishcloths or towels - This could cause a violent steam explosion.

4.Use an extinguisher ONLY if:

A. You know you have a Class ABC extinguisher and you already know how to operate it.

B. The fire is small and contained in the area where it started.

C.The fire department is being called.

D.You can fight the fire with your back to an exit.

*Based on “Kitchen Fire safety Tips” published by NFPA.

CAUTION !

1.For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors.

2.To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall spray, construction dust, etc. off power unit.

3.Your hood motor has a thermal overload which will automatically shut off the motor if it becomes overheated. The motor will restart when it cools down. If the motor continues to shut off and restart, have the hood serviced.

4.For best capture of cooking impurities, the bottom of the hood should be a minimum of 24” and a maximum of 30” above the cooking surface.

5.To reduce the risk of fire and to properly exhaust air on a ducted installation, be sure to duct air outside - Do not exhaust air into spaces within walls or ceiling or into attics, crawl spaces, or garage.

6.This product is equipped with a thermostat which may start blower automatically. To reduce the risk of injury and to prevent power from being switch on accidentally, switch power off at service panel and lock or tag service panel.

7.The Jenn-Air hood must be installed with blower models H325B or H326B only. Other blowers cannot be substituted. (Blowers sold separately).

8.Use with approved cord-connection kit only.

9.Please read specification label on product for further information and requirements.

Warranty

Safety

Operation

Cleaning

Installation

Service Parts

3

Image 3
Contents JXT-B Series Range Hood Warranty Table of ContentsTo Reduce the Risk of a Range TOP Grease Fire Safety InstructionsHeat Sentry Operation CleaningOptional Parts Tools Needed for Hood InstallationParts Included with Hood Parts not Included with HoodJENN-AIR JXT-B Range Hood System Model H326B Blower / Rough-in KitRough-in Kit Operation Prepare the Hood LocationOption Prepare the HoodWarranty Safety Operation Install the HoodRefer to page 5 for ordering information Connect the WiringWiring Diagram Finalize the InstallationInstall Filters Description Service PartsHotte de cuisinière Série JXT-B Garantie Table DES MatièresAfin DE Réduire LES Risques DE FEU DE Cuisinière Instructions DE SécuritéHeat Sentrymc Fonctionnement EntretienOutils NÉ Cessaires PIÈ CES ComprisesPièces NON Comprises PIÈ CES OptionnellesHotte Ventilateur Modèle H325B Système DE Hotte DE Cuisinière JENN-AIR JXT-BCouvre-conduits Pro Style optionnel Voir page 17 pour Ventilateur/Plaque ventilateur modèle H326BConduits Standards Ventilateur Simple Modè LE H325B PRÉ Paration DE LA Localisation DE LA HottePréparation DE LA Hotte Garantie Installation DE LA HotteSché MA É Lectrique Finalisation DE L’INSTALLATIONVoir en page 17 pour les détails de commande Branchement ÉlectriqueInstallation DES Filtres Logo Jenn-Air Pièces DE RemplacementCampana de cocina Serie JXT-B Garantia Tabla DE ContenidoAdvertencia Instrucciones DE SeguridadHeat Sentrytm Operación LimpiezaHerramientas Necesarias Piezas IncluidasPiezas no Incluidas Piezas OpciónalSistema DE LA Campana JENN-AIR JXT-B Ventilador / PlacaCampana Del ventilador Modelo H325B Garantìa Seguridad Operación Prepare LA Localización Para LA CampanaOpció N Prepare LA CampanaMontura Instale LA CampanaRefierse en página 29 para información sobre pedido Conecte EL CableadoEsquema ELÉ Ctrico Terminar LA InstalaciónInstale LOS Filtros Pieza no Descripciõn Piezas DE Servicio