Install the Hood, Warranty Safety Operation

INSTALL THE HOOD

1.Rest the back cavity of the hood on the wood mounting strip.

CAUTION: Hold the hood until it is completely ! secured to the wood mounting strip.

Secure hood to wood strip with (4) screws #8 - 3/4” (for 30” and 36” width hoods) or (6) screws (for 48” width hood) provided at location shown. Drill (2) 3/16” size holes into the drywall for wall anchors through the existing holes in the inside hood back in the locations shown. Then install the (2) wall anchors and attach the hood to these anchors with the remaining #8 - 3/4” screws and the (2) washers provided.

HD0064

2.Attach transition (if required) to blower rough-in plate. Refer to page 6 for available models.

Use duct tape to make all joints secure and air-tight.

NOTE

Model H325B blower plate connects directly to 7” round duct without a transition.

Top of hood (inside view)

Mounting screw locations

Back of hood (inside view)

Wall anchor locations

Warranty

Safety

Operation

HD0049

3.Run power cable to installation location. Refer to the instructions included with the selected blower / rough-in kit (sold separately) for details on installing the rough-in plate. Install the rough-in plate so that the wiring box is located on the right side as you are facing the hood.

For ducting through back of hood, remove existing plate from inside back of hood and attach to inside top of hood to cover hole. Secure to threaded studs with same (4) nuts.

For ducting through top of hood, existing plate remains in place on inside back of hood.

Connect ducting to transition or rough-in plate as you are

installing the rough-in plate. Use duct tape to make all
joints secure and air-tight.	HD0063

Plate on top of hood Locknuts

Rough-in plate on back of

hood

Locknuts

Wiring

cover

Cleaning

Installation

Service Parts