PREPARE THE HOOD
1.Using a Phillips #2 or a Robertson #2 screwdriver, unscrew the hood from the bottom of crate. Refer to figure to the right to locate all 4 screws. Discard these screws and remove hood from wood pallet.
HR0002
OPTION |
A Pro Style backsplash is available (see page 5 for more details). This backsplash must be installed before the hood shell because the hood shell covers the backsplash top mounting screws. In order to be able to install the backsplash, make sure you have at least 18” (457 mm) clearance between bottom of hood and range control panel or cooktop. (Refer to instructions included with backsplash.)
2.Measure and mark a level line on wall above cooktop location for the wood mounting strip (see illustrations to the right and under step 2 on page 7). Use
CAUTION: Due to the weight of this hood,
!ensure that the wood strip is attached to all of 
the available wall studs (2 studs minimum for the 30” hood, more as hood width increases);
not into drywall alone.
3 | 4 |
1 | 2 |
7
1.Drywall
2.Wood Mounting Strip
3.Flat Head Screw
4.Wall Anchor Location
5.Outline of the Back of the Hood
6.Wall Studs
8